Section: Prepare Before Installing
Prepare Before Installing Specifications
Owner’s Responsibility
Incorrect installation, adjustment, and use of this burner could result in severe personal injury, death, or substantial property damage from fire, carbon monoxide poisoning, soot or explosion.
Contact a professional, qualified service agency for the installation, adjustment and service of your oil heating system. This work requires technical training, trade experience, licensing or certification in some states and the proper use of special combustion test instruments.
Please carefully read and comply with the following instructions:
yNever store or use gasoline or other flammable liquids or vapors near this burner or appliance.
yNever attempt to burn garbage or refuse in this appliance.
yNever attempt to light the burner/appliance by throwing burning material into the appliance.
yNever attempt to burn any fuel not specified and approved for use in this burner.
yNever restrict the air inlet openings to the burner or the combustion air ventilation openings in the room.
Impaired Burner Performance
and Fire Hazard.
Do NOT operate the burner beyond specifications outlined in the table to the right.
yFor applications beyond these limits, consult Beckett Technical Service at
yNOTE: Some packaged appliances with burners may be agency listed as a unit to operate beyond these limits. Consult the appliance manufacturer’s specifications and agency approvals for verification.
Capacity | ‘F’ Head |
| Firing Rate: 0.75 - 2.50 GPH |
| Input: 105,000 - 350,000 Btu/h |
|
|
Fuels | USA: No. 1 or No. 2 diesel fuel or kerosene; |
| No.1 or No. 2 heating oil (ASTM D396) |
|
| DO NOT USE GAS- |
|
| |
| OLINE, CRANKCASE OIL, OR ANY | |
| OIL CONTAINING GASOLINE. | |
|
|
|
Electrical | Power Supply: 13.5 Vdc | |
| Operating Load | |
| w/ igniter on: 15 Amps | |
| w/ igniter off: 8 - 10 Amps | |
| Motor: 13.5Vdc, 1/6 hp, 3450 RPM, 10 | |
| Amps (max.) NEMA “M” Flange, rotation | |
| CCW when facing shaft end. | |
| Ignition Secondary: 20KVpk 25mA | |
| Interrupted duty OR optional continuous | |
| duty. | |
|
|
|
Pump | Outlet pressure: Note 1 | |
|
|
|
Dimensions | Height (maximum): 11 ½ inches | |
| Width (maximum): 14 3/8 inches | |
| Depth (chassis only): 6 9/16 inches | |
| Air tube diameter: 4 inches | |
|
|
|
Ambient | +32° F. (0° C.) Minimum | |
Operating | +115° F. (+46° C.) Maximum | |
Temperature | (See Warning on Impaired Burner | |
| Performance and Fire Hazard.) |
Note 1. See equipment manufacturer’s burner specifications for recommended outlet pressure. Pressure is 100 psig unless otherwise noted.
Notice Special Requirements
If you discover damage to the burner or controls during unpacking, notify
the carrier at once and file the appropriate claim.
When contacting Beckett for service information — Please record the burner serial number (and have available when calling or
writing). You will find the serial number on the silver label located on the left rear of the burner. See Figure 1.
12 Vdc ADC Burner Manual
3