1
2
Fig. 2.4: Active control elements on the rear panel of the
Use the enclosed power cord to connect the unit to the mains.
FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local voltage matches the voltage indicated on the unit, before you attempt to connect and operate the CX3400. Blown fuses may only be replaced by fuses of the same type and rating. Some models allow for inserting the fuse holder in two different positions, in order to switch over from
3
5
6
and | 10 | HIGH OUTPUT connector. Output for the High band signal. |
and | 12 | LOW (LF SUM) OUTPUT connector. Output for the Low band signal. |
and | 13 | XOVER FREQ. button. This button serves to switch over the control range of the front- |
panel LOW/HIGH OVER FREQ. control from 44 to 930 Hz or 440 Hz to 9.3 kHz.
+Always switch off the entire system before you press this button, as it produces heavy interference noise that could damage your speakers and/or other equipment.
8
MODE button. In stereo
+Always switch off the entire system before you press this button, as it produces heavy interference noise that could damage your speakers and/or other equipment.
9
14
15
LOW SUM button. In stereo mode, the two Low paths can be summed with the LOW SUM button and routed to the Low output of channel 1, which is particularly useful in systems using additional sub- woofers.
INPUT connector. Input signal connector.
SERIAL NUMBER. Please take the time to have the warranty card filled out completely by your specialized dealer, and return it within 14 days after the date of purchase, so as to be entitled to benefit from our extended warranty.
2.2.2 Stereo
First, activate stereo
Fig. 2.5: Proper selection of the two MODE switches for stereo
Subsequently, the LEDs above the active controls on the front panel light up, signaling which controls are active in the operating mode you just selected. The functions of these controls can be seen from the second strip label. In stereo mode, both channels perform the same functions.
10 | 2. THE DESIGN CONCEPT |