VIRTUALIZER PRO DSP2024P
1
Fig. 1.2: Display section of the VIRTUALIZER PRO
Both the LED CHAINS display the intensity of the input signal in dB in relation to the nominal level, which is selected on the rear panel with the OPERATING LEVEL switch.
2
3
4
5
After you switch on the VIRTUALIZER PRO, you can read the name of the last used effect on the LED DISPLAY. When editing, the LED DISPLAY shows the parameter’s name along with a
To the right of the LED DISPLAY are four STATUS LEDs which indicate the type of value you are working with. You may do any of the following:
set the absolute value of an effect parameter (“%”),
increase or decrease the amplitude or determine the threshold point of the compressor (“dB”),
modify a frequency (“Hz”) or
modify a time parameter (“sec”).
The ALGORITHM GROUPS LED CHAIN indicates which category the selected effect belongs to. Altogether the DSP2024P offers eight different algorithm groups.
Fig. 1.3: Function keys, controls and jog wheel
Every preset in the DSP2024P allows you to edit at least four effect parameters. The
controls the parameter EDIT A, controls EDIT B, helps in changes of parameter EDIT C and
with you change the setting of parameter EDIT D. If the middle LED of the
For the exact meaning of the individual effect parameters, see chapter 7.1.
8 | 1. INTRODUCTION |