ULTRAGAIN PRO MIC2200
9
The x 0.1 switch lowers the working range of the FREQUENCY control to 10 - 200 Hz, so that you can process the bass end of the audio spectrum.
10
The x 10 switch raises the working range of the FREQUENCY control to 1 - 20 kHz, so that you can process the treble end of the audio spectrum.
11
12
13
14
15
The BANDWIDTH control determines the slope or quality of the filter. Bandwidth ranges from 0.03 (Q = 43) to 2 octaves (Q = 0,67).
With the LEVEL control you can set the amount of level reduction/gain applied to the filter. The setting range is from
The EQ IN/OUT switch activates/deactivates the parametric EQ. Please switch the EQ off unless you need it for your specific audio application.
The OUTPUT control raises/lowers the output level of the device by a maximum of 20 dB (+/- 20 dB). With the control in
The OUTPUT LEVEL LED chain displays the output level within a range from
4.2 Rear panel control elements
11
12
13
14
15
Fig. 4.2: Rear panel elements of the ULTRAGAIN PRO
SERIAL NUMBER. Please take the time to fill in and return the warranty card within 14 days after the date of purchase, so as to benefit from our extended warranty. Or use our online registration option available on the World Wide Web at www.behringer.com.
FUSE HOLDER / VOLTAGE SELECTOR. Please make sure that your local voltage matches the voltage indicated on the unit, before you attempt to connect and operate the ULTRAGAIN PRO. Blown fuses may only be replaced by fuses of the same type and rating.
MAINS CONNECTION. Use the enclosed power cord to connect the unit to the mains. Please also note the instructions given in the “INSTALLATION” chapter.
AUDIO IN. These are the audio inputs of your ULTRAGAIN PRO. The XLR connector is the common mic/line input. The line input is based on jack connection.
AUDIO OUT. These are the audio outputs of your ULTRAGAIN PRO. Matching phone jack and XLR connectors are wired in parallel.
14 | 4. CONTROL ELEMENTS |
