Behringer UP1000 manual Color Frame, Dismounting the lens, Mounting the lens

ULTRAPAR UP1000

3.1Dismounting the lens

+The lens gets very hot during operation of the spotlight, so let it cool down sufficiently before you attempt to dismount it!

sDisconnect the spotlight from the mains and wait until it has cooled down.

sPlace the spotlight on a flat and stable surface. Never mount or dismount the lens, while the spotlight is fixed to a truss or stand.

sRemove the protective mesh : press its two spring shackles, then pull out the mesh.

sDirectly in front of the lens, you will find a movable metal clamp attached to the lens ring. Turn the lens ring, until the metal clamp is located on the top side of the spotlight (directly below

the locking bracket ).

sTilt the front side of the spotlight forward by at least 45°.

sPush the movable metal clamp upward to dismount and pull out the lens .

3.2Mounting the lens

sTilt the spotlight forward and turn the lens ring, until the movable metal clamp is located on

the top side of the spotlight (directly below the locking bracket ).

sInsert the lens with its rounded side towards the rear. The lower edge of the lens must be

located behind the projecting elements of the lens ring.

+Inserting the lens with its rounded side towards the front does not effect the optics of your ULTRAPAR, but will make it more difficult to dismount the lens later on.

sPress the upper edge of the lens slightly towards the rear, until it locks in behind the metal clamp

.

sInstallation of the protective mesh : Press the two spring shackles of the protective mesh and place it directly in front of the lens ring . There are two slots in the die-cast casing of your ULTRAPAR for the “feet” of the protective mesh. The two spring shackles must be located

directly below the locking bracket .

4. COLOR FRAME

The color frame is used to hold the color foils. Please observe the following instructions to install the color frame:

sDetach the locking bracket on the top side of the spotlight, by pushing it to the side. Then, open the bracket and tilt it towards the rear.

sInsert the color frame into the frame holders and , i.e. the outer guiding rail (with stops on three sides) on the front side of the ULTRAPAR.

sPush the locking bracket to the side and move it down until it locks in.

4. COLOR FRAME 5