49X32 DIGITAL MIXER Preliminary User Manual

5.Adjust the 3rd encoder to select for coarse range

•Insert

•Main (LRC)

•Mix Bus

•Matrix

•Direct Out

•Monitor

6.Adjust 4th encoder to select specific signal path to feed the selected physical output. Choices include:

•Insert Point

•Main L

•Main R

•Main C/M

•Any of the 16 Mix Outputs

•Any of the 6 matrix outputs

•Any of the 32 direct outputs

•Any of the 8 Auxiliary Outputs

•Any of the FX Direct Outputs

•Monitor L

•Monitor R

•Talkback

7.Tap the 4th encoder to assign the selected output path, completing the process.

8.Adjust the 5th encoder to select the signal tap point for the output assignment. Choices include:

•Input

•Pre-EQ

•Pre-Fader

•Post-Fader

9.Tap the 5th encoder to complete the signal tap point assignment.

7.4.4 Routing Screen: P16 Tab

The routing screen’s P16 tab allows the user to route various console signal paths to the rear panel P16 Ultranet output. The Ultranet output allows for 16 channels of audio to be sent, in digital form, to various accessories such as a personal monitoring distribution box.

Using the P16 routing screen, the user can configure the P16 output to carry not only the main LR mix, but also various audio “stems” of program material sources from a bus send mix, such as a stereo drum mix, stereo keyboards, guitars, bass, vocals, etc. Musicians on stage would then be free to each craft their own personal mix of these musical stems, all delivered from the FOH position to stage over a single Ethernet cable.

To select which audio signals are sent to the P16 bus, perform the following steps:

1.Adjust the 1st encoder to select which of the 16 channels in the P16 bus you wish to select an audio source for.

2.Adjust the 3rd encoder to select a category of audio source to send to the currently selected P16 channel. These categories include:

•Insert

•Main (LRC)

•Mix Bus

•Matrix

•Direct Out

•Monitor

3.Adjust the 4th encoder to select which specific signal path to feed to the currently selected P16 output. Choices include:

•Off

•Main L

•Main R

•Main C/M

•Any of the 16 Mix Outputs

•Any of the 6 matrix outputs

•Any of the 32 direct outputs

•Any of the 8 Auxiliary Outputs

•Any of the FX Direct Outputs

•Monitor L

•Monitor R

•Talkback

4.Tap the 4th encoder to assign the selected output path, completing the process.

5.Adjust the 5th encoder to select the signal tap point for the output assignment. This determines where in the audio signal path the source is “tapped” as it is sent to the P16 output. The available signal tap points include:

•Input

•Pre-EQ

•Pre-Fader

•Post-Fader

6.Tap the 5th encoder to complete the signal tap point assignment.