6.2-Turning on the TV and Setting the Channels
When you turn on your television for the first time, FIRST TIME INSTALLATION
CHECK AERIAL CABLE IS CONNECTED. PRESS OK KEY TO CONTINUE message is displayed. If the antenna connections
are correct, press OK button to continue. COUNTRY SELECTION menu will be displayed. Select the country by using Up/Down, Right/Left movement buttons and press OK button to start the auto programming. Channel Searchmenu will be displayed and Digital channels are scanned and stored in the memory.
After completion of the searching process Channel Search Results menu will be displayed. Number of TV and Radio channels already detected and stored in the memory at the end of the search process will be displayed in this menu. Finish the Digital channel searching process by pressing the OK button.
PRESS OK KEY TO START ANALOG SEARCH PRESS MENU KEY TO EXIT message will be displayed. You can make Analog channel tuning with OK button
or finish the searching process by pressing the MENU button.
6.3-Performing Digital Tunings
You can either tune the Digital programs automatically or manually and store them in your television.
6.3.1-Automatic Tuning of Channels and Storing in the Memory
Press AV button on your remote control, select DIGITAL tab from the
SOURCE menu by using Up/Down 
movement buttons and confirm by 
pressing the OK button. Your TV
will switch to Digital mode. Press MENU button, MAIN MENU will be
displayed. Select SETUP tab with down movement button and confirm with the OK button. SETUP menu will be displayed.
SETUP
AUTO TUNING
MANUEL TUNING
FIRST TIME INSTALLATION
SELECT | MENU |
MENU BACK |
Select AUTO TUNING tab and confirm by pressing the OK button. COUNTRY SELECTION menu will be displayed.
COUNTRY SELECTION
BELGIUM | NORGE |
CZECH REP. | ÖSTERREICH |
DANMARK | POLSKA |
DEUTSCHLAND | PORTUGAL |
ELLADA | SCHWEIZ |
ESPANA | SUOMI |
FRANCE | SVERIGE |
HUNGARY | TÜRKİYE |
IRELAND | U.K. |
ITALIA | .......................... |
NETHERLANDS
START AUTOPROGRAMMING
MENU BACK
Select the country by using Up/ 
Down, Right/Left movement 
buttons and press OK button to start
the auto programming. Channel Searchmenu will be displayed and Digital channels are scanned and stored in the memory.
Channel Search
Waiting for signal...
Service found:
TV: 0 | Radio: 0 | Other: 0 |
Stop Search
Note: You can also access Auto Tuning menu from the System Menu submenu under Digital Features menu.
6.3.2-Manual tuning of channels and storing in the memory
Press MENU button in digital mode and MAIN MENU will be displayed. Select SETUP tab with down movement button and confirm with the OK button. SETUP menu will
10
