INSTALLATION INSTRUCTIONS
1.The space in the room where the appliance is installed must not be smaller than 10 cubic metres.
2.Do not put your fridge freezer in a cold room where the temperature is likely to go below +5 degrees C (41 degrees F) during night time and/or especially in winter.
This fridge freezer has been designed to operate in ambient temperatures
between +5 and +32 degrees C (41
and 90 degrees F) Therefore if the appliance is installed in an unheated/
cold room (eg: conservatory/annex/ shed/garage etc) then the appliance
will not operate causing the freezer compartment to run warmer and as a
result the storage time of frozen food may be reduced.
3.Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder. If installed next to a source of heat or freezer, maintain the following minimum side clearances:
From Cookers | 50 mm (2”) |
From Radiators | 300 mm (12”) |
From Freezers | 25 mm (1”) |
4.Make sure that | sufficient room |
is provided around the appliance to ensure free air circulation.Fit the Two plastic wall spacers supplied with the appliance by rotating 1/4 turn to the condenser at the back of the appliance (See Diagram).
8
5.The fridge/freezer should be located on a smooth surface. The two front
feet can be adjusted as required. To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or
to prepare your appliance for use.
7.A special receptacle is supplied to store the mains plug during transit. The receptacle is fixed at the back of the cabinet, on the left hand side of the compressor. (See diagram) Gently remove the plug from the receptacle. Never pull the mains cord, you may damage the appliance. In the case of transportation,ensure you locate the plug in the receptacle provided to avoid transit damage.
EN |
