GB | Instruction Manual |
|
|
Electrical requirements
Before inserting the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply.
We recommend that this appliance be connected to the mains supply via a suitably switched and fused socket in a readily accessible position.
Warning! This appliance must be earthed. Repairs to electrical equipment should only be performed by a qualified technician. Incorrect repairs carried out by an unqualified person carry risks that may have critical consequences for the user of the appliance.
Transportation instructions
1.The appliance should be transported only in upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance, has been positioned horizontally, it must not be operated for at least 4 hours, to allow the system to settle.
3.Failure to comply with the above instructions could result in damage to the appliance, for which the manufacturer will not be liable for.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
Important!
•Do not attempt to sit or stand on top of your appliance as it is not designed for such use.
You could injure yourself or damage the appliance.
•Make sure that the mains cable is not caught under the appliance during and
after moving, as this could damage the cable.
•Do not allow children to play with the appliance or tamper with the controls.
Installation instructions
1.Do not keep your appliance in a room where the temperature is likely to fall below 10 degrees C at night and/or especially in winter, as it is designed to operate in ambient temperatures between +10 and +43 degrees C. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food.
2.Do not place the appliance near cookers or radiators or in direct sunlight, as this will cause extra strain on the appliance's functions. If installed next to a source of heat or freezer, maintain the following minimum side clearances:
From Cookers 30 mm From Radiators 300 mm From Freezers 25 mm
3.You can find the door handles on the cabinet shelf and the related assembly components in the salad crisper. Assemble the handles to the doors (Fig.
4.For efficient functioning, there should be a gap of at least 5cm between the refrigerator and the wall. To ensure this, attach the two round buffers to be found inside the No Frost appliance, as shown in the illustration (Fig.6).
2
