Electrical requirements
Before inserting the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your
electricity supply.
We recommend that this appliance be connected to the mains supply via a suitably switched and fused socket in a readily accessible position.
Warning! This appliance must be grounded.
Repairs to electrical equipment should only be performed by a qualified technician. Incorrect repairs carried out by an unqualified person are carry risks that may have critical consequences for the user of the appliance.
Transportation instructions
1.The appliance should be transported only in a upright position. The packing as supplied must be intact during transportation.
2.If during the course of transport the appliance, has been positioned horizontally, it must not be operated for at least 4 hours, to allow the system tosettle.
3.Failure to comply with the above instructions could result in damage to the appliance, for which the manufacturer will not be held liable.
4.The appliance must be protected against rain, moisture and other atmospheric influences.
Important!
•Do not attempt to sit or stand on top of your appliance as it is not designed for such use. You could injure yourself or damage the appliance.
•Make sure that the mains cable is not caught under the appliance during and
after moving, as this could damage the cable.
Instructions for use
•Do not allow children to play with the appliance or tamper with the controls.
Installation instructions
1.Do not keep your appliance in a room where the temperature is likely to fall below 10 degrees C at night and/or especially in winter, as it is designed to operate in ambient temperatures between +10 and +43 degrees C. At lower temperatures the appliance may not operate, resulting in a reduction in the storage life of the food.
2.Do not place the appliance near cookers or radiators or in direct sunlight, as this will cause extra strain on the appliance's functions. If installed next to a source of heat or a freezer, maintain the following minimum side clearances: From Cookers 30 mm
From Radiators 300 mm From Freezers 25 mm
3.Make sure that sufficient room is provided around the appliance to ensure free air circulation.
• Fit the two round wedges given with your refrigerator to their places. These wedges provide free
• Fit the bottom airing lid given in your appliance as shown in the diagram to the pins facing one another on the feet at the bottom of the door. Make sure claws and pins to hold each other for the
4.The appliance should be positioned on a smooth surface. The two front feet can be adjusted as required.To ensure that your appliance is standing upright adjust the two front feet by turning clockwise or counter clockwise, until firm contact is secured with the floor. Correct adjustment of feet prevents excessive vibration and noise.
5.Refer to "Cleaning and Care" section to prepare your appliance for use.
2