Beko DRCS 68 S, DRCS 68 W manual Solution suggestions for problems

9Solution suggestions for problems

Problem	Cause	Explanation / Suggestion
Drying process	Cover filter and filter drawer might
takes too much		* Clean the cover filter and Filter drawer.
	have not been cleaned.
time.
Laundry come out	* Cover filter and filter drawer might
	have not been cleaned.	* Clean the cover filter and Filter drawer.
wet at the end of
	* Excessive laundry might have been	* Do not overload the machine.
drying.
	loaded in.
	* It might have not been plugged in.
	* The loading door may be ajar.	* Make sure that the machine is plugged in.
Machine does not	* Programme might have not been set	* Make sure that the loading door is
switch on or the	or the “Start/Pause/Cancel” button	properly closed.
programme does	might have not been pressed.	* Make sure that the programme has been
not start. Machine	* “Childproof lock” might have been	set and it is not in “Pause” mode.
is not activated	activated.	* Deactivate the childproof lock.
when set.	* The condenser cover on the models	* Make sure that the condenser cover and
	with a condenser might not be closed	the red lock is closed securely.
	securely.
Programme has		* Make sure that the loading door is
	* The loading door may be ajar.	properly closed.
been interrupted
	* Electricity may be cut off.	* Press “Start/Pause/Cancel” button to
without any cause.
		start the programme.
		* Dry only the laundry which is suitable for
Laundry has		drying in your machine after checking the
shrunk, become	* A programme suitable for the laundry	labels on your clothes.
felted or	type might have not been used.	* Select a programme with suitable low
deteriorated.		temperature for the laundry type to dry your
		clothes.
Drum lightning
does not come on.	* The machine might have not been	* Make sure that the machine is On.
(for models	started by using the On/Off button.	* Call the authorized service to replace the
equipped with a	* Bulb may have blown.	bulb.
lamp)
“Final / Anti-	* The 2-hour anti creasing programme	* Turn off the machine and take out the
creasing” LED	to prevent laundry from creasing might	laundry.
flashes.	have been activated.
“Final / Anti-		* Turn off the machine and take out the
creasing” LED is	* Program has come to an end.
		laundry.
on.
The “Drying” LED	* A heat sensor failure has occurred.	* Turn off the machine and take out the
	Machine ends the programme without
flashes.		laundry. Call your authorized service.
	heating.
“Filter cleaning”	* Filter might have not been cleaned.	* Clean the cover filter.
LED flashes.
Also for products equipped with a condenser
“Water tank”	* Water may be full.
	* Anti-creasing programme might be	* Drain the water in the water tank.
warning LED is on.
	running.
“Condenser	* Filter drawer/Condenser might have	* Clean the filters in the condenser/filter
cleaning” LED is
	not been cleaned.	drawer under the kick plate.
on.

A Call an authorized service agent if the problem persists.

23 - EN