Beko HSA 20520 manual Setting up, Electric connection, Switching off, Instruction for use

Models: HSA 20520

1 12
Download 12 pages 22.13 Kb
Page 7
Image 7

EN

Instruction for use

 

 

￿Excess deposit of ice on the frame and the baskets should be removed regularly with the plastic scraper provided. Do not use any metal parts to remove the ice.

The presence of this ice build-up makes impossible to close the door correctly.

￿If you do not use your appliance for a few days, it is not advisable to switch it off. If you do not use it for a longer period, please proceed as follows :

- unplug the appliance; - empty the freezer;

- defrost it and clean it;

- leave the door open to avoid the formation of unpleasant smells.

￿The supply cord can be replaced only by an authorised person.

￿If your appliance has a lock, keep it locked and store the key in a safe place, out of the reach of children. If you are discarding an appliance with lock, make sure that, is made ineffective. This is very important so as to avoid children being trapped inside, which may cause their loss of life.

Setting up

This appliance was designed to operate at an ambient temperature between +100C and +430C (SN-T class). If the ambient temperature is above +430C, inside the appliance the temperature can increase.

Set up the appliance far from any source of heat and fire. Placing it in a warm room, the direct exposure to sunbeams or near a heat source (heaters, cookers, ovens), will increase the energy consumption and shorten the product life.

Please observe the following minimun distances:

100 cm from the cookers working with coal or oil;

150 cm from the electric and gas cookers.

Ensure the free circulation of the air around the appliance, by observing the distances shown in Item 2.

Assemble on the condenser (in the rear side)

the supplied spacers (Item 3).

3

 

Place the appliance in a perfectly even, dry and well ventilated place.

Assemble the supplied accessories.

Electric connection

Your appliance is intended to operate at a single-phase voltage of 220-240V/50 Hz. Before plugging in the appliance, please make sure that the parameters of the mains in your house (voltage, currect type, frequency) comply to the operation parameters of the appliance.

The information concerning the supply voltage and the absorbed power is given on the marking label placed in the back side of the freezer.

The electric installation must comply with the law requirements.

The earthing of the appliance is compulsory. The manufacturer has no responsibility for any damage to persons, animals or goods which may arise from the failure to observe the specified conditions.

The appliance is endowed with a supply cord and a plug (European type, marked 10/16A) with double earthing contact for safety. If the socket is not the same type with the plug, please ask a specialised electrician to change it.

Do not use extension pieces or multiple adapters.

Switching off

The switching off must be possible by taking the plug out of the socket or by means of a mains two-poles switch placed before the socket.

Page 7
Image 7
Beko HSA 20520 manual Setting up, Electric connection, Switching off, Instruction for use