Beko HSA 20520 manual Inside cleaning, Outside cleaning, Replacing the interior light bulb

Models: HSA 20520

1 12
Download 12 pages 22.13 Kb
Page 10
Image 10

EN

Instruction for use

 

 

Inside cleaning

Before starting the cleaning, unplug the appliance from the mains.

It is advisable to clean the appliance when you defrost it.

Wash the inside with lukewarm water where you add some neutral detergent. Do not use soap, detergent, gasoline or acetone which can leave a strong odour.

Wipe with a wet sponge and dry with a soft cloth.

During this operation, avoid the excess of water, in order to prevent its entrance into the thermal insulation of the appliance, which would cause unpleasant odours.

Do not forget to clean also the door gasket especially the bellow ribs, by means of a clean cloth.

Outside cleaning

Clean the outside of the freezer by means of a sponge soaked in soapy warm water, wipe with a soft cloth and dry.

The cleaning of the outside part of the refrigerating circuit (motorcompressor, condenser, connection tubes) will be done with a soft brush or with the vacuum-cleaner. During this operation, please take care not to

distort the tubes or detach the cables.

Do not use scouring or abrasive materials !

After having finished the cleaning, replace the accessories at their places and plug in the appliance.

Replacing the interior light bulb

If the lamp burns out, disconnect the appliance from the mains. Take out the lamp trim. Make sure the lamp is screwed correctly. Plug in the appliance again. If the lamp still does not go on, replace it with another one model E14-15W. Mount back the lamp trim in its place.

Defects finding guide

T h e a p p l i a n c e d o e s n o t w o r k .

￿There is a power failure.

￿The plug of the supply cord is not inserted well into the socket.

￿The fuse is blown.

￿The thermostat is in „OFF” position .

T h e t e m p e r a t u r e s a r e n o t l o w e n o u g h (red LE D on) .

￿The food prevents the door closing.

￿The appliance was not placed correctly.

￿The appliance is placed too close to a heat source.

￿The thermostat knob is not in the correct position.

Ex c e s s i v e i c e bui l d - u p

￿The door was not closed properly.

T he f o l low i n g a re n o t d ef e c t s

￿Possible noddings and cracks coming from the product: circulation of the refrigerant in the system.

6

Page 10
Image 10
Beko HSA 20520 manual Inside cleaning, Outside cleaning, Replacing the interior light bulb, Defects finding guide