IMPORTANT

INSTALLATION INSTRUCTIONS

1. The space in the room where the appliance is installed must not be smaller than 10 cubic metres.

2. If possible avoid placing the appliance near cookers, radiators or in direct sunlight as this will cause the compressor to run for long periods. If installed next to a source of heat or refrigerator, maintain the following minimum side clearances:

From Cookers

2"

(50 mm)

From Radiators

12" (300 mm)

From Refrigerators or Larder Fridge

1"

(25 mm)

 

 

 

3. Make sure that sufficient room is provided around the appliance to ensure free air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the appliance and the ceiling or the underside of a wall cupboard.

4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn to the condenser at the back of the appliance (See diagram).

5. The appliance should be located on a smooth surface. The two front feet can be adjusted as required.

To ensure that,your appliance is standing

Electronic card

(covered by plastic cover)

upright adjust the two front feet by turning

 

clockwise or anti-clockwise, until the product

 

is in firm contact with the floor. Correct

 

adjustment of feet avoids excessive

 

vibration and noise.

 

6. Refer to "Cleaning and Care" section to

 

prepare your appliance for use.

 

7. A special receptacle is supplied to store the

 

mains plug during transit.

 

The receptacle is fixed at the back of the

 

cabinet, on the right hand side of the

 

compressor. (See diagram) Gently remove

 

the plug from the receptacle. Never pull

 

the mains cord, you may damage the

 

appliance. In the case of transportation,

 

ensure you locate the plug in the receptacle

 

provided to avoid transit damage.

 

STARTING

Final Check

Before you start using the freezer check that:

1.The feet have been adjusted for perfect levelling.

2.The interior is dry and air can circulate freely.

3.Clean the interior as recommended under "CLEANING AND CARE."

4.Insert the plug into the wall socket and switch on the electricity supply.

5.You will hear a noise as the compressor starts up. The liquid and gases sealed within the refrigeration system may also give rise to noise, whether the

compressor is running or not which is quite normal.

6.We recommend that you set the thermostat knob at 3 (three) and monitor the temperature to ensure the appliance maintains desired storage temperatures (See

section Temperature Control and Adjustment).

7.Do not load the appliance immediately it is switched on. Wait until the correct storage temperature has been reached. We recommend that you check the

temperature with an accurate thermometer (see; Temperature Control and Adjustment).

Important Notes :

1.If there is a power failure do not open the door. Frozen food should not be affected if the failure lasts for less than 25 hours. If the failure is longer, then the food should be checked and either eaten immediately or cooked and then re-frozen.

2.If you find the freezer door difficult to open just after you have closed it, don't worry. This is due to the pressure difference which will equalise and allow the door to open normally after a few moments.

3.You will hear a suction sound just after closing the door. This is quite normal.

5

6

Page 3 Page 5
Page 4
Image 4
Beko TZDA 503 manual Electronic card
Page 3 Page 5

TZDA 503 specifications

The Beko TZDA 503 is a highly efficient and modern upright freezer that has garnered attention for its impressive features, advanced technologies, and user-friendly characteristics. Designed with functionality and performance in mind, this freezer is ideal for households seeking ample storage space for frozen goods.

One of the standout features of the Beko TZDA 503 is its generous storage capacity. With a total net volume of 148 liters, this freezer offers plenty of room to store your frozen foods, whether it's fruits, vegetables, meats, or pre-prepared meals. The adjustable shelves provide flexibility, allowing users to customize the storage space according to their needs.

In terms of design, the Beko TZDA 503 showcases a sleek, modern aesthetic that fits seamlessly into any kitchen environment. Its vertical arrangement makes it easy to access items, while the door features a user-friendly handle that ensures effortless opening and closing. Additionally, the appliance is equipped with a reversible door, allowing homeowners to adjust the door swing direction based on their kitchen layout.

The Beko TZDA 503 is also packed with innovative technologies aimed at enhancing efficiency and performance. One notable feature is its Frost Free technology, which eliminates the need for manual defrosting. This not only saves time but also maintains optimal storage conditions without the hassle of ice buildup. The appliance operates at a quiet noise level, ensuring minimal disruption in the home.

Energy efficiency is another key characteristic of the Beko TZDA 503. With an energy rating of A++, this freezer is designed to consume less energy while delivering powerful freezing capabilities. This translates to lower electricity bills and a reduced environmental impact, making it an economical choice for conscientious consumers.

Temperature management is made easy with the adjustable thermostat, allowing users to set their desired freezing level depending on the type of food stored. The internal lighting ensures visibility and makes locating items quick and convenient.

Overall, the Beko TZDA 503 stands out as a reliable and efficient appliance for any kitchen. Its impressive capacity, advanced technologies, and user-centered design make it a popular choice among consumers looking for a dependable freezer that meets their freezing needs. Whether for bulk buying, meal preparation, or preserving seasonal produce, the Beko TZDA 503 is well-equipped to handle a variety of storage needs.
Top Page Image Contents