The door is jammed.
-Water level might be above the lower level of the door.
-Machine might be heating up the
water or it may be at the spinning | - Run either the “Pump” or “Spin” program. |
cycle. | - Wait until the process is over. |
- Due to an electrical mechanism, | - Wait until the process is over. |
the door can only be opened a |
|
few minutes after the program has |
|
stopped. |
|
Machine fills with water when a process is cancelled.
Inside of machine may be hot.
For safety reasons, water should be cycled in and out a couple times.
It continuously spins. Remaining time does not count down. (On models with display)
There may be an imbalance of laundry in the machine.
-The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum.
-The laundry in the drum may be clustered
(bundled laundry in a bag). Laundry should be rearranged and
-No spinning is performed when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its environment.
Washing time takes longer than the time specified in the manual
-Water pressure may be low.
-Supply voltage may be low.
-Input temperature of water may be low.
-There may be an imbalance of laundry in the machine.
-Number of rinses and/or amount of rinse water might have increased.
-The machine will wait until there is sufficient amount of water, which will lengthen the washing time to avoid poor washing results due to insufficient water.
-Washing time is extended to avoid poor washing results when the supply voltage is low.
-Cycle time is extended to heat up the water when the input water is cold. Also, washing time can be lengthened to avoid poor washing results.
-The automatic spin correction system might have been activated due to the unbalanced distribution of the laundry in the drum.
-The laundry in the drum may be clustered
(bundled laundry in a bag).
-Laundry should be rearranged and
-No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any damage to the machine and to its environment.
-Water amount is increased to obtain a better rinse and a rinse cycle is added when necessary.
30
EN
