Bel Canto Design manual CD-2Front Panel Operation, CD-2Operating Mode Display

CD-2 Front Panel Operation

CD-2 Operating Mode Display:

Several Operating Modes are displayed using the left-most 7-segment display:

Two Vertical Lines Indicate Pause, a Square indicates Stop, a Blinking Segmented Square indicates Play.

Standby is indicated by two dashes - -

CD-2 in Fixed Output Mode (Fixed/Variable IN):

Upon application of power the CD-2 goes through a display check and comes up in Standby, indicated by two dashes on the display - -.

Place a CD on the CD-2 and then place the magnetic puck on the CD. It will automatically center and clamp itself in place.

Press the center of the front panel control for 2-3 seconds, you will then see the firmware revision displayed for a couple of seconds and the CD will spin while 4 dashes are displayed. Once the CD Table Of Contents is read the display will indicate the total CD time and the number of tracks.

A 01 display indicating track 1 with 2 vertical dashes in the left hand mode indicator display will indicate that the CD-2 is in Pause mode and is ready to play the CD.

Initiate Play by pressing the front panel control once. Scan to a new track by

rotating the control. This works while in Pause, Play or Stop modes.

To Pause while playing press the con- trol once.

To Stop at any time press the control twice. The CD-2 will remain on the cur- rent track on re-start the track when Play is started.

A center press on the control will be acknowledged by the display brighten- ing momentarily.

When in Play mode the mode indicator shows a square with sequenced blinking segments.

Stop is indicated by a stationary square. The CD will be stopped. In Play and Pause modes the CD will continue to rotate.

CD-2 in Variable Output Mode (Fixed/Variable OUT):

Operation will be the same as above accept that rotating the front panel con- trol while in Stop or Play mode will indi- cate the volume level and then change the volume up or down as the control is rotated.

Rotating the control in Pause mode will change the track number to be played. The volume display will stay lit for sever- al seconds and then the display will go back to the mode indicator/track num- ber display.

© 2007 bel canto design, Ltd. page 7 CD-2 User’s Guide 0607revA