Belkin F1DN102U manual Connecting Computers to the Switch required

Installation

Step 3 Connecting Computers to the Switch (required)

3.1Make sure all computers and the Switch are powered off.

3.2Using the Belkin All-In-One USB KVM Cable Kit (F3X1962bXX), connect the male VGA connector to the monitor port on your computer. Then connect the female VGA connector to the CPU monitor port on the Switch labeled “VGA 01”. (Refer to diagram below.)

3.3Using the Cable Kit, connect the USB Type A connector to an available USB port on your computer. Then connect the USB Type B connector to the USB port on the Switch labeled “USB 01”. (Refer to diagram below.)

3.4Repeat steps 2 and 3 for each additional USB computer you wish to connect.

Note: The Cable Kit must be connected directly to a free USB port on your computer, with no USB hubs or other devices in between.

12