Extension Unit
4.Plug the extension unit into an AC electrical outlet near where you want a new phone jack.
5.Plug telephone’s line cord into the extension unit.
6.Please note: Installation is not complete until you perform the steps outlined in the Security Programming directions below. Once this is done, you will be able to hear a dial tone on your phone.
Wall Outlet
Extension Unit
Security Programming
The base and extension units are now connected to your telephone system. After completing steps
1.Using a small pointed object, such as a pen or pencil tip, press the black recessed button on the side of the base unit. The green light on the front of the base unit will come on and stay lit during the security programming sequence.
Note: Once the button is pressed, you must program the extension unit within five minutes. If the
Base Unit
Green Light
2.Using the same small pointed object, press the black recessed button on the side of the extension unit. The green light on the front of the extension unit will flash once. This is your notification that the security programming for this extension is complete. To program additional extensions to the same base, repeat step 2 with the additional extensions.
Note: When the button is pushed on the extension, the light on the extension should come on for a few seconds, and then go out. This indicates that the unit is operating properly. If the green light is flashing repeatedly, your base unit is not in programming mode. You will need to return to step 1 and repeat the steps.
Extension Unit
Green Light
3.Once all extensions have been programmed, you will need to verify the dial tone for each phone. Take your phone off the hook and listen: you should hear a dial tone.
4
