Installing and Setting Up the Adapters
Table of Contents | sections | 1 | 2 | 3 | 4 |
Overview
Installation of the Powerline Networking Adapters takes only minutes and does not require setting up long wires throughout the house. Simply plug the Adapters into the wall and connect the Ethernet cable into your device. You may optionally install the included utility to monitor your powerline network. This utility is not required for operation.
Hardware Setup
1.Plug your network cable into an RJ45 network adapter port.
2.Plug the other end of your network cable into the RJ45 port located at the bottom of the Adapter.
3.Plug the power cable into the power connector at the back of the Adapter.
4.Plug the power plug of your power cable directly into a power outlet in the wall.
Note: Do not plug the device into a UPS or power strip with surge protection as they may filter the powerline signal.
5.Repeat this process for the second Adapter
Powerline Networking Adapters | 4 |
