Bell'O 8325, 8315 manual When mounting to a wood stud

When mounting to a wood stud

When you have prepared the holes for mounting the Wall Plate (WP), place the plate over the holes and screw in the Lag Bolts (T), as shown in Figure 7. Leave some “wiggle” room so that you can make any fine adjustments, if necessary. After making sure the wall mount is level, tighten all of the lag bolts completely.

Figure 7

Supporting

Stud

WP

Supporting

Stud

Wall

T

Tighten the Lag Bolts (T) so that the Wall Plate (WP) is firmly attached to the wall, but don’t over-tighten! The lag bolts and/or the supporting surface can become damaged, which greatly reduces their holding ability. Final tightening of the bolts should always be done by hand, with a Phillips-head screwdriver or ratchet wrench.

English