BenQ 2000 Series user manual Recovering Your System, Recovering From Your Hard Disk

JB2000E.book Page 30 Tuesday, March 23, 2004 8:57 AM

Recovering Your System

Before following any of the methods below to restore your system, you should try to use Microsoft Windows XP System Restore tool to restore under Windows. If you don't know where the System Restore tool is, you can just insert the Recovery CD Disc 1 into the optical drive under Windows, then Recovery CD will launch the Windows XP System Restore tool automatically.

System recovery is a data destructive process. You should backup all data and applications prior to restoring. Please make sure your system is connected to AC Power before continuing.

Recovering From Your Hard

Disk

Your Joybook provides you with a quick recovery method from its hard drive.

To recover using the quick recovery method:

1.Restart your Joybook.

2.During the restart process, press the F10 key when you see the "<" symbol displayed on the upper-left part of the screen. The system will then enter the Quick Recovery mode.

3.Follow the instructions on the screen to complete the recovery process.

Recovering Using the Recovery CDs

You should receive a Recovery CD pack containing CDs that you can use to rebuild your system. These Recovery CDs will help you to restore the hard disk with the original content that was installed when you purchased your Joybook. Follow the steps below to rebuild your hard disk.

The Primary Partition (Drive C:) will be reformatted. The data files on Extended Partition (Drive D:) will not be erased.

To recover your system using the recovery CDs:

30 Recovering Your System

1.When Joybook starts up, press the Esc key to enter the Boot Menu during Power-On Self-Test (POST) while the BenQ Joy- book logo is being displayed.

2.Insert the Recovery CD Disc 1 into the CD-ROM drive.

3.Select CD-ROM/DVDfrom Boot Menu and press the Enter key.

4.Then system will boot from CD-ROM and you will see the Quick Restore screen.

5.When you finish the recovery process, remember to remove the Recovery CD.

Reinstalling Software or Driver

To install/reinstall the software or driver that was installed when you purchased your Joybook, you could find the source files on the Recovery CD Disc 2.

After recovering your system using the Recovery CDs, please fol- low the steps below to re-install the wireless LAN driver and utility program.

1.Insert Recovery CD Disc 2 into the optical drive of your Joy- book.

2.Click the Start button on Windows Taskbar and then select Run....

3.According to the operating system of your Joybook, enter the following path in the Run dialog that appears and then click OK:

For Windows 2000:

E:\Drivers\Wlan\WIN2K\Driver\sinstall.exe

For Windows XP:

E:\Drivers\Wlan\WINXP\Driver\sinstall.exe

4.Follow the on-screen instructions to complete the installation process. When done, restart your Joybook.

5.Click the Start button on Windows Taskbar and then select Run....