2.Press MENU/EXIT and then press 
/ 
until the SYSTEM SETUP: Advanced menu is highlighted. Press 
to highlight Network Settings and press MODE/ENTER. The Network Settings page is displayed.
3.Highlight Wired LAN and press MODE/ENTER.
4.Make sure the Status is Connect.
5.Press 
to highlight DHCP and press 
/ 
to select On.
6.Press 
to highlight Apply and press MODE/ENTER.
7.
If the IP Address still does not appear, contact your ITS administrator.
If you are in a non-DHCP environment:
1.Repeat steps
2.Press 
to highlight DHCP and press 
/ 
to select Off.
3.Contact your ITS administrator for information on the IP Address, Subnet Mask, Default Gateway, and DNS settings.
4.Press 
to select the item you want to modify and press MODE/ENTER.
5.Press 
/ 
to move the cursor and the press 
/
to enter the value.
6.To save the settings, press MODE/ENTER. If you do not want to save the settings, press MENU/EXIT.
7.Press 
to highlight Apply and press MODE/ENTER.
Controlling the projector remotely through a web browser
Once you have the correct IP address for the projector and the projector is on or in standby mode, you can use any computer that is on the same local area network to control the projector.
• If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.
•The screenshots in this manual are for reference only, and may differ from the actual design.
1.Enter the address of the projector in the address bar of your browser and press Enter.
Operation 35
