MIXING
This section explains operation of the mixer and how to install | Fig. 3 |
bowls and agitators. |
|
BOWL
New mixer bowls and agitators (beaters, whips, spiral dough hook, ingredient chute and splash cover) should be thoroughly washed with hot water and a mild soap solution, rinsed with either a mild soda or vinegar solution, and thoroughly rinsed with clear water before being put into service. This cleaning procedure should also be followed for bowls and agitators before whipping egg whites or whole eggs.
The bowl must be installed before the agitator. To install the bowl, fully lower the bowl support (Fig. 3).
60 quart Mixer - Position the bowl so two holes on bowl tabs are above the bowl pins on the bowl support.
AGITATOR
To install an agitator (Fig. 4), the bowl must be installed and fully lowered. Place the agitator in the bowl, push it up on the agitator shaft, and turn it clockwise to seat the shaft pin in the slot of the agitator shank.
Fig. 4
ATTACHMENTS
To install an attachment, loosen the thumb screw on the attachment hub (Fig.1, page 4) and remove the plug. Insert the attachment into the attachment hub making certain that the square shank of the attachment is in the square driver of the mixer. Secure the attachment by tightening the thumb screw.
The meat and food chopper attachment must be operated in Speed 3 or lower. If material in the cylinder stalls the mixer, stop the mixer at once. Do not attempt to restart the mixer in a lower
Attachment hub must not be used while mixing product.
Close bowl guard/wire cage and raise bowl support to mix position, move the speed select knob to the desired speed and start the mixer to operate the attachment. If bowl support is lowered off the mix position, mixer will stop
FMS60 Owner/Operator Manual | – 7 – |
