Maintenance
Routine Inspection
Record
I. QUARTERLY INSPECTION | III. QUARTERLY INSPECTION |
Inspect all system piping connections for leakage or possible misalignment.
Check pump foundation for soundness and see that all
Complete any lubrication requirements as dictated by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Inspect pumping plant panel for signs of wear (ie: replace pitted contactors, etc., as needed).
Check pump and motor bearings from signs of wear. Repack or replace as necessary.
Check alignment of couplings and/or pulleys and belt tension if applicable.
________________________________________
II. QUARTERLY INSPECTION
Inspect all system piping connections for leakage or possible misalignment.
Check pump foundation for soundness and see that all
Complete any lubrication requirements as dictated by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Inspect pumping plant panel for signs of wear (ie: replace pitted contactors, etc., as needed).
Check pump and motor bearings from signs of wear. Repack or replace as necessary.
Check alignment of couplings and/or pulleys and belt tension if applicable.
________________________________________
NOTES:
Inspect all system piping connections for leakage or possible misalignment.
Check pump foundation for soundness and see that all
Complete any lubrication requirements as dictated by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Inspect pumping plant panel for signs of wear (ie: replace pitted contactors, etc., as needed).
Check pump and motor bearings from signs of wear. Repack or replace as necessary.
Check alignment of couplings and/or pulleys and belt tension if applicable.
________________________________________
IV. QUARTERLY INSPECTION
Inspect all system piping connections for leakage or possible misalignment.
Check pump foundation for soundness and see that all
Complete any lubrication requirements as dictated by pump and driver owner’s manual.
Inspect packing or mechanical seal for possible replacement. Examine shaft sleeve, if present, for
wear and replace if necessary.
Inspect pumping plant panel for signs of wear (ie: replace pitted contactors, etc., as needed).
Check pump and motor bearings from signs of wear. Repack or replace as necessary.
Check alignment of couplings and/or pulleys and belt tension if applicable.
________________________________________
ANNUAL INSPECTION
Inspect pump and entire pumping system for signs of wear.
Inspect system valves, screens, etc.
If electric motor is used, check windings for degred- ation, rewind if necessary.
Check pump impeller eye for clearance.
Inspect impeller, volute case, and seal chamber for signs of excessive wear or corrosion.
Page 22 | F00633 |
