ELECTRICAL CONNECTION
This unit is manufactured for a polarized, grounded 120 volt/60 Hz, 15 amp system.
Electric power consumption is about 300 W.
The minimum of 102 VAC is required for proper operation of gas ignition systems.
The circuit must be grounded and properly polarized.
The unit is equipped witth a SJT power cord. In case of replacement, the power cord shall be replaced with one of the same type, size and length.
ELECTRICAL GROUNDING
This appliance is equipped with a three‐prong plug for your protection against shock hazard and should be plugged directly into a properly grounded socket. Do not cut or remove the grounding prong from this plug.
WARNING!
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit breaker box or fuse box before installing the appliance.
Provide appropriate ground for the appliance.
Use copper conductors only.
Failure to follow these instructions could result
in serious injury or death
CAUTION
Label all wires prior to disconnecting when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
WIRING DIAGRAM
12
