INSTALL MOUNTING
BRACKET
(DUCTED OR NON-DUCTED HOODS)
1.Construct wood wall framing that is flush with interior surface of wall studs.
Make sure:
a)the framing is centered over installation location.
b)the height of the framing will allow the mounting bracket to be secured to the framing within the dimensions shown.
2.After wall surface is finished, secure mount- ing bracket to framing using dimensions shown.
FRAMING BEHIND CROSS SUPPORT
WOOD CROSS SUPPORT
BEHIND DRYWALL
DRYWALL
CEILING |
| HOOD DISTANCE ABOVE 36” HIGH COOK TOP (SEE NOTE BELOW) |
| ||||||
DUCT METHOD | 24” | 25” | 26” | 27” | 28” | 29” | 30” |
| |
HEIGHT | MOUNTING BRACKET LOCATION ABOVE 36” HIGH COOK TOP |
| |||||||
|
|
| |||||||
8 FEET | DUCTED OR |
|
| ||||||
NON DUCTED |
|
| |||||||
|
|
|
|
|
|
|
|
| |
9 FEET | DUCTED OR |
|
| ||||||
NON DUCTED |
|
| |||||||
|
|
|
|
|
|
|
|
| |
10 FEET | DUCTED WITH |
| |||||||
| FEXTK8087 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Note: minimun hood distance above cook top must not be less than 24”. A maximum of 30” above cook top is highly recommended for best capture of cooking impurities. Distances over 30” are at the installer and users discretion; and if ceiling height and flue length permit.
INSTALL FLUE MOUNTING BRACKET
DUCTED AND NON-DUCTED
1.Assemble the flue mounting bracket, adjusting outside width as shown. Fig.4
2.Carefully center the mounting bracket directly over the range hood location.
3.Securethebracketassemblytotheceiling using (2) 4.8x38mm mounting screws and drywall anchors. Make sure the bracket is pushed into the corner, tight against the wall and centered over the hood.
FLUE MOUNTING
BRACKET 3.9 x 5.7mm
FLAT HEAD
BRACKET SCREWS
9 3/4”
FIG. 4
- 9 -