Part No 440021 Form No F071307B
9
FORCE BLOWER Owner’s Manual
ASSEMBLY
Figure A Figure B
1.Follow the steps in figures A and B, then securely tighten all hardware shown.
2.Connect spark plug wire.
The hardware for attaching the upper handle to the lower
is in the parts bag. Install upper handle (item 30), to
preassembled lower handle (item 28) by sliding the upper
over and down the outside of the lower handle. Using bolt
(item #36), washers (item #10) & lock nut (item #11) to
install upper handle to lower handle. Finish installing the
other side of the upper handle assembly using screw and
lock nut provided.
The throttle control and will be attached to the throttle arm
on the engine and wrapped around the engine for
shipping. Unwrap and secure throttle control (item #31) to
upper handle with screws (item #17). Screws will already
be mounted in handle, simply remove and use to mount
the throttle control securing the cable with two Ty-wraps.
The Aim-and-Shoot TM is not attached, you will need to
unroll the cable and attach the ball end to the lever and
seat the cable end into the hole on the saddle clamp, with
the cable running through the slot. To keep the cable
from being damaged use three ty-wraps (item 74) to
secure it to the handle as shown making sure that the
cable is not rubbing against the tire.
Two ½” open ended wrenches
One 5/16 open ended wrench