ASSEMBLY
Assembly requires two people. | Set the treadmill in a cleared area and remove all packing materials. Do not | ||
dispose of the packing materials until assembly is completed. | Assembly requires the included allen wrench | ||
and your own phillips screwdriver |
| and wire cutters | . |
Note: The underside of the treadmill walking belt is coated with
| Handrail Bolt |
Extension Leg Screw/Handrail Screw | Console Screw |
1.Carefully raise the Uprights (11) until the treadmill is in the position shown.
Insert one of the Extension Legs (34) into the treadmill as shown. (Note: It may be helpful to tip the Uprights
[11]in the direction shown by the arrow as you insert the Extension Leg.) Make sure that the Base Pad (40) is on the indicated side of the Extension Leg. Attach the
Extension Leg with an Extension Leg Screw (53). | Be | |
sure to push on the head of the Extension Leg |
| |
Screw while tightening it. | Attach the other Extension | |
Leg (not shown) in the same way. |
|
|
2. Slide a Handrail Cap (41) onto one of the Handrails (1)
as shown. Insert the Handrail (1) into the tube at the top of the left Upright (11). Slide a Handrail Bolt (78) onto a Handrail Bracket (91). Finger tighten the Handrail Bolt
1 |
|
|
|
|
| 11 | 11 |
|
|
| |
|
|
| 53 |
|
|
| 34 |
|
|
| 40 |
2 | 53 |
| 53 |
|
|
(78)at an angle (see the inset drawing) into the Upright and the Handrail. Make sure that the Handrail Cap (41)
is around the Upright.
1
Holes
Press the top of the Handrail (1) into the left Upright (11). Align the indicated hole in the Handrail with the hole in
the Upright, and tighten a Handrail Screw (53) into the Upright and the Handrail. Then, tighten the Handrail Bolt (78).
Attach the other Handrail (1) as described above.
|
|
| 11 |
|
|
| 1 |
41 | 91 |
| 41 |
|
| 78 | 91 |
|
|
| |
11 |
|
| 78 |
91 |
|
| |
1 | 78 |
|
|
5
