17 | MAINTENANCE continued |
17.1CABLE ADJUSTMENTS
CAUTION: DO NOT make cable adjustment when engine is running. Disconnect spark plug wire before making any adjustments.
Brake Adjustment
The brake control cable is spring loaded and requires no adjustment; however, the transaxle brake is adjustable. When the mower is in neutral and can
be pushed by hand without depressing the brake lever, the transaxle brake needs adjustment.
Using a ½ inch wrench turn the adjusting nut ¼ turn clockwise (see figure
With the machine in neutral and:
1.The brake lever not depressed, the brake should be on and inhibit the machine from being rolled by pushing.
2.The brake lever depressed the brake should be off and the machine should roll uninhibited by the brake.
Figure
Transaxle Drive Control Cable Adjustment
When the transaxle drive belt slips, the drive control cable needs to be adjusted or the belt needs to be replaced with a new belt.
Cable Adjustment:
1.Using a 3/8” wrench, remove the rear access door (Item 51).
2.Using a ½ “open end wrench, turn the inside adjusting screw clockwise 1/8 of a turn and then tighten the outboard adjusting nut against the support bracket (see figure
3.Check for proper operation. If the operation is not correct, repeat step 2.
4.Replace the access door.
The drive control cable adjustment should be the minimum amount required so the belt does not slip when the drive is engaged.
Blade Drive Control Cable Adjustment
When the blade drive control lever is depressed, the blades should turn and the blade drive belt should not slip. When the cable is properly adjusted the tension spring on the end of the control cable will open slightly (only enough for a piece of paper to slip between the coils). See figure
Cable Adjustment:
1.Remove the deck belt cover (Item 81).
2.Observe the tension spring on the end of the cable when the blade drive lever is depressed. The spring should just break open.
3.If adjustment is required, using a ½” open end wrench, turn the inboard adjustment nut clockwise 1/8 of a turn (Figure 4). Then tighten the outboard adjustment nut against the cable support bracket (Item 49).
4.Check the spring tension with the blade drive lever depressed.
5.Readjust the control cable as needed for proper tension.
6.Replace the deck belt cover.
Note: Too much tension will shorten belt and bearing life and too little tension will allow the belt to slip.
Figure
17.2STARTER SWITCH WIRING
TO BATTERY (BATTERY TERMINAL ON BATTERY)
RED CONDUCTOR
TO STARTER SOLENOID
WHITE CONDUCTOR
TO STOP SWITCH TERMINAL ON ENGINE
GREEN/YELLOW CONDUCTOR
TO GROUND
BLACK CONDUCTOR
Figure
Part No. 520141 | Page 11 of 20 | Form No. F061604A |
