HP Owner’s Manual
PACKING CHECKLIST
Your Billy Goat Mower is shipped from the factory in one crate, completely assembled except for the handles and controls.
READ all safety instructions before assembling unit.
TAKE CAUTION when removing the unit from the box.
PUT OIL IN ENGINE BEFORE STARTING
PARTS BAG &
LITERATURE ASSY
Warranty card P/N- 400972, Owner’s Manual P/N-521302.
Boxing Parts
Checklist
Briggs and
Stratton Intek
Parts Bag checklist
ASSEMBLY
NOTE: All item numbers called out in the assembly, operation, and maintenance sections of this manual can be found on Parts List (pages
1.Remove the unit from the box, be careful when removing it as there are cables that could be damaged by the machine when rolling it out of the box.
2.Attach the upper handle assembly to the lower handle assembly using the hardware found in the holes located on the lower handle.
3.Attach the throttle cable to the upper handle with the hardware located in the hole on the right side of the upper handle.
4.Attach the drive and blade cables levers to the upper handle using the hardware provided. Note: The blade cable will also need to be attached to the console. To attach it run one of the nuts off of the thread and slide the cable through the slot then run the nut back down and tightening it. The standard setting should be positioned near the bottom of the barrel of the cable. For fine tuning the lever see page 14 for cable tension adjustments.
5.Make sure that all cables and levers function properly. They should not kink or bind in anyway.
6.Using the
7.Fill with oil and gas to the proper level and the unit is ready to mow.
8.Read the rest of the operator’s manual.
Part No 521302 | 8 | Form No F101910A |
|
|