Billy Goat KD 410 Sound, Vibration, In The Interest Of Safety, Warning Do Not, 104 dB

4IN THE INTEREST OF SAFETY

BEFORE STARTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL & EN- GINE MANUAL.”

THIS SYMBOL MEANS WARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.

WARNING: The Engine Exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

13. DO NOT tamper with governor springs,

22. DO NOT run engine without air cleaner

WARNING: DO NOT

governor links or other parts which may

or air cleaner cover.

change the governed engine speed.

23. DO NOT operate during excessive

1. DO NOT run engine in an enclosed area.

14. DO NOT tamper with the engine speed

vibration!

Exhaust gases contain carbon monoxide, an

selected by the engine manufacturer.

24. DO NOT leave machine unattended

odorless and deadly poison.

15. DO NOT check for spark with spark

while in operation.

2. DO NOT place hands or feet near moving

plug or spark plug wire removed. Use an

25. DO NOT park machine on a steep

approved tester.

or rotating parts.

grade or slope.

3. DO NOT store, spill or use gasoline near

16. DO NOT crank engine with spark plug

WARNING: DO

removed.

an open flame, or devices such as a stove,

1. ALWAYS DO remove the wire from the

furnace, or water heater which use a pilot

17. DO NOT strike flywheel with a hard

light or devices which can create a spark.

spark plug when servicing the engine or

object or metal tool as this may cause

equipment TO PREVENT ACCIDENTAL

4. DO NOT refuel indoors where area is not

flywheel to shatter in operation. Use

STARTING.

proper tools to service engine.

well ventilated. Outdoor refueling is

2. DO keep cylinder fins and governor

recommended.

18. DO NOT operate engine without a

parts free of grass and other debris

muffler. Inspect periodically and replace, if

5. DO NOT fill fuel tank while engine is

which can affect engine speed.

necessary. If engine is equipped with

running. Allow engine to cool for 2 minutes

muffler deflector, inspect periodically and

3. DO pull starter cord slowly until resis-

before refueling. Store fuel in approved

replace, if necessary, with correct deflector.

tance is felt. Then pull cord rapidly to avoid

safety containers.

kickback and prevent hand or

arm

6. DO NOT remove fuel tank cap while

19. DO NOT operate engine with an

injury.

accumulation of grass, leaves, dirt or other

engine is running.

4. DO examine muffler periodically to be

combustible material in the muffler area.

sure it is functioning effectively. A worn or

7. DO NOT operate engine when smell of

leaking muffler should be repaired or

gasoline is present or other explosive

20. DO NOT use this engine on any forest

replaced as necessary.

conditions exist.

covered, brush covered, or grass covered

8. DO NOT operate engine if gasoline is

unimproved land unless a spark arrester is

5. DO use fresh gasoline. Stale fuel can

installed on the muffler. The arrester must

gum carburetor and cause leakage.

spilled. Move machine away from the spill

be maintained in effective working order by

6. DO check fuel lines and fittings fre-

and avoid creating any ignition until the

the operator. In the State of California the

gasoline has evaporated.

quently for cracks or leaks. Replace if

above is required by law (Section 4442 of

necessary

9. DO NOT transport unit with fuel in tank.

the California Public Resources Code).

Other states may have similar laws.

7. Follow engine manufacturer operating

10. DO NOT smoke when filling fuel tank.

Federal laws apply on federal lands.

and maintenance instructions.

11. DO NOT choke carburetor to stop

21. DO NOT touch hot muffler, cylinder, or

8. Inspect machine and work area before

fins because contact may cause burns.

starting unit.

engine.

THE BRIGGS AND STRATTON ENGINE ON THIS EQUIPMENT CANNOT BE SOLD IN THE STATE

12. DO NOT run engine at excessive

OF CALIFORNIA.

speeds. This may result in injury & /or

6

SOUND

7

VIBRATION

damage to unit.

VIBRATION LEVELS 2.0g

Sound tests conducted were in accordance with 2000/14/EEC

Vibration levels at the operators handles were

and were performed on 2/21/2002 under the conditions listed:

measured in the vertical, lateral, and longitudinal

5

TABLE OF CONTENTS

NOTE: Sound power level listed is the highest value for any model in this manual. Please

directions using calibrated vibration test equipment.

Tests were performed on 11/20/98 under the conditions

refer to serial plate on the unit for the sound power level for your model.

listed:

SAFETY INSTRUCTIONS

2

Sound level of 98 dBA at operator position

GENERAL SAFETY

3

GENERAL CONDITION:

Sunny

GENERAL CONDITION:

Sunny

ASSEMBLY

3

50°

F (10.0° C)

LABELS . . . . . . . . . . . . . . . . . . . . 4

TEMPERATURE:

45° F (7.2° C)

TEMPERATURE:

OPERATION

5

WIND SPEED:

8 MPH (12.9 kmh)

WIND SPEED:

5 MPH (8.1 kmh)

PARTS DRAWING & LIST

6 - 7

104 dB

west

South West

MAINTENANCE

7 - 8

WIND DIRECTION:

WIND DIRECTION:

TROUBLESHOOTING

8

HUMIDITY:

60 %

HUMIDITY:

54 %

WARRANTY PROCEDURE

8

30.23" Hg (768mm Hg)

BAROMETRIC PRESSURE:

30.18" Hg (767mm Hg)

BAROMETRIC PRESSURE:

Part No. 890564 Page 2 of 8 Form No. F022502A