Manuals / Billy Goat / Lawn and Garden / Brush Cutter

Billy Goat SC120H specifications Fig

Models: SC120H

1 46

Download 46 pages 13.32 Kb

Page 25

Fig. 11

!After use store the machine in a place where fuel vapours cannot reach a na- ked flame or sparks.

!In the instance of a long period of non-use, drain the fuel tank completely.

Use of the machine does not require specific lighting.

However, the recommended minimum amount of light (e.g. 200 lux) to be able to read the notices on the machine and to operate it without running risks caused by poor light.

CHECKING AND REPLACING THE TRANSMISSION OIL.

Check the transmission oil level using the relative oil level screw ( fig. 11 ref. C). If oil leaks out upon removal of this screw then there is enough of it in the transmis- sion. If not, remove the filling cap shown in fig. 11 ref. A, then top up with SAE 90.

The oil should be replaced after the first 20 hours of use and after this every 100 working hours.

Remove the drainage cap shown in fig. 11 ( ref. B) and allow all the oil to run out. After refitting the drainage cap, fill the transmission from the filling cap with SAE 90 transmission oil.

Refit the lid securely to prevent any leakage of oil.

Fig. 11

370310	F112003A
	25

Image 25

Billy Goat SC120H specifications Fig

Contents

THE POWERFUL BILLY GOAT SOD CUTTER OPERATING AND SAFETY INSTRUCTIONSSPECIFICATIONS MODEL: SC120HSOD CUTTER MODEL-SC120H OPERATING AND SAFETY INSTRUCTIONS1.USE OF THE MANUAL Contents of the SOD CUTTER Manual 2.NOTICES ON THE MACHINE 370302 – Label Controls Instruction, Qty. 3.TECHNICAL DATA FOR THE SOD CUTTER SC120H370300 – Label Instructions, Qty. 370310Environmental conditions 4.LIFTING AND TRANSPORTATIONgradients to prevent loss of control 5.MAIN PARTS OF THE MACHINE ABLADE CLUTCH CONTROL LEVER 6.CONTROL AND ADJUSTMENTSB ACCELERATOR CONTROL LEVER CFORWARD CLUTCH CONTROL LEVERF COVER D CUTTING HEIGHT ADJUSTMENT LEVERPART OF THE CUTTING HEIGHT ADJUSTMENT LEVER C PREPARATION 8.SAFETY INFORMATIONdWORKING USE Danger of burns 9.TRANSPORTATION OF THE MACHINE FORWARD CONTROL AND BLADE MOVEMENT LEVERS 10.DESCRIPTION OF THE SAFETY AND GUARD SYSTEMSCOVER Oil recommendationsFigure 12.STARTING AND DRIVING THE SOD CUTTERFigure 4b Figure 4aDRIVING THE MACHINE 13.CUTTING TIPS14.CHECKS CBELT REPLACEMENT AND ADJUSTMENT 370310 Fig. Fig.F112003A 370310 Fig. Fig.F112003A To remove the blade proceed as follows FIG. 15.MAINTENANCE AND STORAGEFig. 17.SEASONAL LONG-TERMSTORAGE PERIODS 16.CLEANING THE MACHINE18.DECOMMISSIONING AND SCRAPPING 20.WARRANTY19.TECHNICAL ASSISTANCE FAULT 21.TROUBLESHOOTING370310 F112003AF112003A 370310370310 NOTESF112003A F112003A 370310PARTS LIST 1/6 PARTS LIST 1/6 CONTINUED Page PARTS LIST 2/6 Page PARTS LIST 3/6 Page PARTS LIST 4/6 Page PARTS LIST 5/6 PARTS LIST 5/6 CONTINUED Page PARTS LIST 6/6 PARTS LIST 6/6 CONTINUED F112003A 370310