C2)FORWARD CONTROL BELT
Remove the blade control belt following the instructions given in the preceding paragraph.
-Remove the blade (Fig.1 Ref. G) following the instructions provided in the section entitled “Blade removal and replacement”.
-Then remove the forward control belt from the lower pulley by turning the belt anticlockwise (Fig. 8 Ref. A e B)
-To fit the new belt follow the procedure in the reverse order.
-Afterwards check that the belt is positioned and working correctly using the relative forward control lever. When this lever is lowered and the belt is at maximum tension, the distance between the belt and the relative belt guides (Fig. 8 Ref. C) should be approximately 2 mm.
-Then make sure that the belt works properly by tugging lightly on the
D) SERVICE BRAKE CONTROL LEVER
The service brake (Fig. 9 Ref. A) is connected to the forward control lever (Fig. 1 Ref. C). With the forward control lever released and the brake engaged ensure that there is play of approximately 2 or 3 mm between the adjustment screw and the brake cable (Fig. 9 Ref B and C).
WARNING
If there is no such play restore it immediately since the brake will not stop the machine once the forward control lever is released. Make sure that the front part of the brake in direct contact with the pulley (Fig. 9 Ref. D) is not worn. If so, replace it.
370406 | 21 | F103104A |