SAFETY 2
5IN THE INTEREST OF SAFETY
BEFORE STA RTING ENGINE, READ AND UNDERSTAND THE “ENTIRE OPERATOR'S MANUAL & ENGINE MANUAL.”
THIS SYMBOL MEANS W ARNING OR CAUTION. DEATH, PERSONAL INJURY AND/OR PROPERTY DA M AGE MAY OCCUR UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.
W ARNING: DO NOT 
1.DO NOTrun engine in an enclosed area. Exhaust gases contain carbon monoxide,an odorless and deadly poison.
2.DO NOT place hands or feet near moving or rotating parts.
3. DO NOT store, spill or use gasoline near an open flame, or devices such as a stove, furnace, or water heater which use a pilot light or devices which can create a spark.
4.DO NOT refuel indoors where area is not wellventilated. Outdoor refueling is recom- mended.
5. DO NOT fill fuel tank while engine is running. Allow engine to cool for 2 minutes before refueling. Store fuel in approved safety containers.
6.DO NOT remove fuel tank cap while engine is running.
7.DO NOT operate engine when smell of gasoline is present or other explosive conditions exist.
13.DO NOT tamper with governor springs, governor links or other parts which may change the governed engine speed.
14.DO NOT tamper with the engine speed selected by the engine manufacturer.
15.DO NOT checkfor spark with spark plug or spark plug wire removed. Use an approved tester.
16.DO NOT crank engine with spark plug removed. If engine is flooded, place throttle in “FAST” position and crank until engine start.
17.DO NOTstrike flywheel with a hard object or metal tool as this may cause flywheel to shatter in operation. Use proper tools to service engine.
18.DO NOT operate engine without a
m uffler. Inspect periodically and replace,if necessary. If engine is equipped with
m uffler deflector, inspect periodically and replace, if necessary, with correct deflector.
19.DO NOT operate engine with an accumulation of grass,leaves,dirt or other combustible material in the muffler area.
21. DO NOT touch hot muffler, cylinder,or fins because contact may cause burns.
22.DO NOTrun engine without air cleaner or air cleaner cover.
23.DO NOT operate during excessive vibration!
24.DO NOT leave machine unattended while in operation.
25.DO NOT park machine on a steep grade or slope.
W ARNING: DO
1. ALW AYS DO remove the wire from the spark plug when servicing the engine or equipment TO PREVENT ACCIDENTAL STA RTING.
2.D O keep cylinder fins and governor parts free of grass and other debris which can affect engine speed.
3.D O pullstarter cord slowly until resis- tance is felt. Then pull cord rapidly to avoid kickback and prevent hand or arm injury.
4.D O examine muffler periodically to be sure it is functioning effectively.A worn or leaking muffler should be repaired or replaced as necessary.
8.DO NOT operate engine if gasoline is spilled. Move machine away from the spill and avoid creating any ignition until the gasoline has evaporated.
9. DO | NOT ransport unit with fuel in tank. |
10. DO | NOT smoke when filling fuel tank. |
11.DO NOT choke carburetor to stop engine. Whenever possible,gradually reduce engine speed before stopping.
20.DO NOT use this engine on anyforest covered, brush covered, or grass covered unimproved land unless a spark arrester is installed on the muffler.The arrester must be maintained in effective working order by the operator. In the State of California the above is required bylaw (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands.
5.D O use fresh gasoline.Stale fuel can gum carburetor and cause leakage.
6.D O check fuel lines and fittings frequently forcracks or leaks. Replace if necessary
7.Follow engine manufacturer operating and maintenance instructions.
8.Inspect machine and work area before startingunit.
12. DO NOTrun engine at excessive |
speeds.This may result in injury & /or |
7SOUND
8VIBRATION
damage to unit. |
6TABLE OF CONTENTS
SAFETY INSTRUCTIONS | 2 |
GENERAL SAFETY | 3 |
ASSEMBLY | 3 |
PA RTS BAG & CONTROLS | 4 |
LABELS | 4 |
OPERATION | 5 - 7 |
MAINTENANCE | 8 - 9 |
PA RTS DRAWING & LIST | 10 - 12 |
TROUBLESHOOTING | 12 |
W ARRANTY PROCEDURE | 12 |
L A
97
LpA
109
O P E R ATO R
SOUND TESTS
Sound tests conducted were in accordance with 79/113/EEC and were performed on 05/20/
94 under the conditions listed:
GENERAL CONDITION: | Sunny | |
|
| |
TEMPERATURE: | 70 F (21.1 | C) |
WIND SPEED: | 3 MPH (4.8 | kmh) |
|
| |
WIND DIRECTION: | N.W. | ||
58 % | |||
HUMIDITY: |
| ||
|
| ||
BAROMETRIC PRESSURE: 30.1" Hg (765mm Hg) | |||
VIBRATION LEVEL 2.7g
Vibration levels at the operators handles were measured in the vertical,lateral, and longitudinal directions using calibrated vibration test equipment. Tests were performed on 05/20/94 under the conditions listed:
GENERAL CONDITION: Sunny
TEMPERATURE: | 70 F (21.1 C) | |||
3 MPH (4.8 kmh) | ||||
WIND SPEED: | ||||
| N.W. | |||
WIND DIRECTION: |
| |||
|
| |||
58 % | ||||
HUMIDITY: |
| |||
|
| 30.1" Hg (765mm Hg) | ||
BAROMETRIC PRESSURE: | ||||
Part No. 890207 | Page 2 of 12 | Form No. F021795E |
