2. Installation
1. Locating the Base unit
The Base unit should be placed on a level surface, in a position where:
the telephone line cable will reach your telephone line socket or extension socket.
it is not close to a sink, bath or shower, or anywhere else where it might get wet.
it is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs, fluorescent lights, etc.
2.Plug the coiled handset cord into the Handset. Plug the other end into the jack on the left side of the Base unit.
3.Place the Handset in the Base unit.
4.Plug the telephone line cord into the PHONE LINE jack at the back of the Base unit. Plug the other end
into a modular wall jack. 
Installing Backup batteries
1.Remove the Battery cover and insert 3 X 1.5V AA size alkaline batteries (not included) into the battery compartment paying attention to the polarity marking as shown inside the compartment.
2.Replace the battery cover until it clicks into place.
Warning: Disconnect the telephone from the telephone line before changing the batteries.
5.Lift the Handset and check for Dial tone in the earpiece.
Always use the telephone line cord supplied with your SpeakEasy 5. Other telephone line cords may not work.
Note: The Caller display will not work without batteries installed.
4
