Bionaire manual For BCH3210, For BCH3220

For BCH3210:

1.Set the THERMOSTAT knob to the highest setting, clockwise as far as it will turn.

2.When the desired room temperature level is reached, lower the thermostat setting, by turning the THERMOSTAT knob counter clockwise as far as

it will turn.

3.The thermostat will now automatically maintain the pre-set temperature level by turning the heater on and off. The thermostat is now set.

Figure 1		High
	Low		Current Room
Fan			Temperature
			Indicator
ff			Set Temperature
			Higher
		Power	Lower
		Button

Mode

HIGH ROOM SET

LOW TEMP. TEMP.

FAN

AUTO

mode	thermostat
				Set
	Mode			Temperature
	Button	Light	Night Light Indicator
BCH3210		Sensor	Button	BCH3220

For BCH3220:

1.To change the heater settings, press the MODE button. Each time you press the MODE button, it will scroll through the settings FAN, LOW, HIGH, AUTO.

Note: The fan speed will not change when the mode is changed from low to high.

2.Select the AUTO mode.

3.Set the heater to the desired room temperature by pressing the (+) or (-) buttons.

Note that the degree range is from 60°F - 85°F (15°C - 29°C). If you scroll past 85°F (29°C) the display will automatically loop to 60°F (15°C).

4. Now the desired temperature is set.

Note: When the temperature in the proximity of the heater reaches the set temperature, the heater will automatically turn on. The fan will continue to run cooling the heater for 30 seconds. The unit will operate again when the temperature falls below the preset temperature.

4