SMARTTOUCH™ THERMOSTAT INSTRUCTIONS
To take advantage of the SmartTouch™ Thermostat continue to press the MODE/OFF button until the desired temperature is set in either the HIGH (1500 Watt) or LOW (750 Watt) setting. When ambient temperature rises above the set temperature, the heater will stop.
When the ambient temperature drops below the set temperature, the heater will turn on automatically.
Note: When the SmartTouch™ thermostat is set, either the HIGH or LOW power light, and the set temperature light will remain lit during operation.
Note: It is normal for the heater to cycle ON and OFF as it maintains the preset temperature. To prevent the unit from cycling, you need to raise the thermostat setting.
Note: SmartTouch™ has memory. The SmartTouch™ thermostat will remember the previous temperature setting after the unit has been turned off. However, if the unit is unplugged, the SmartTouch™ thermostat will be reset and will no longer remember the previous temperature setting.
REMOTE CONTROL OPERATION
1.Before operation, insert 2 AAA batteries into the back of the remote control.
•Do not mix old and new batteries.
•Do not mix alkaline, standard
2.Press the power button ( 
) on the remote control to begin operation. Press the button a second time to turn the heater off.
3.To change the heat or thermostat settings, press the mode button. The mode button will scroll through the two heat settings, then switch into Auto mode so that the thermostat can be adjusted. Once in Auto mode, continue to press the mode button until the desired temperature setting is reached.
OSCILLATION (BFH3416 ONLY)
For maximum heat distribution use the oscillation function.
1.Press the Oscillation button on the remote control to begin 90° oscillation.
2.To stop the heater from oscillating, press the Oscillation button a second time; the unit will stop in that direction. To resume oscillation, press the Oscillation button again.
Note: The oscillation feature can only be operated from the Remote Control.
DO NOT attempt to turn oscillation by hand. Severe damage to the mechanism could result.
MAINTENANCE INSTRUCTIONS
During Season Care
Before cleaning make sure the unit is unplugged.
1.Allow the heater to cool before cleaning.
2.Carefully wipe the unit with a soft, damp cloth.
3.Please be cautious near the heating elements.
☛TIP: Over time, dust may accumulate on the front grills. This can be removed by wiping the unit with a damp cloth. Always unplug unit and allow to cool prior to cleaning.
After Season Care
Store heater in a cool, dry location. Bionaire® recommends storing the unit in its original, or appropriately sized, box.
TROUBLESHOOTING
☛If your heater fails to operate:
✔Make sure the electrical outlet or circuit breaker is working.
✔Check for obstructions. If you find an obstruction turn the heater OFF, and follow the Reset Instructions in the manual. Carefully remove the obstruction.
✔The thermostat might be set too low. Adjust the thermostat until the heater restarts.
Please DO NOT attempt to open or repair the heater. Please see the Warranty for Service Instructions.
4 | 5 |
