Bionaire CP0260 manual Filling the Water Tank, Using the Medication CUP

•Once the humidity level is reached, the unit stops producing moist air, until the humidity drops below the preset level, at which time it once again starts to produce moist air.

When attempting to humidify large areas with large amounts of air circulation, the Automatic Humidistat control can normally be left in the high position (control turned completely to the right). However, in small areas, or those which have minimal air circulation, a lower setting will be necessary. Your personal comfort will determine the best setting for you. If moisture forms on walls or windows, lower the setting or turn off the humidifier.

FILLING THE WATER TANK

Figure 3	When the water tank is empty, the “EMPTY/CLEAN”
	light will illuminate and no moist air will be
	produced until the water tank is refilled.

1.Switch the humidifier off.

2.Lift out the tank and carry it to a water tap.

3.Twist the tank cap counter-clockwise approximately 1/4 turn. The cap should now lift away.

4.Fill the tank with cool tap water.

5.Replace the tank cap, making sure the large O-ring is in its correct position.

6.Carry the full tank with both hands and carefully replace it into your humidifier. Wait a few minutes for the tray to refill.

7.Turn the unit back on.

8.Press the “RESTART” button. The “EMPTY/CLEAN” light should extinguish and moist air will be emitted within a few minutes.

Note: At maximum setting, the tank may last up to 25 hours. At minimum setting, the tank may last up to 50 hours. Do not add any additives to the water in the tank or tray.

WARNING: All cleaning agents must be thoroughly rinsed away after use and before the unit is returned to service.

USING THE MEDICATION CUP

A medicated vapor can be distributed with the “mist” output.

To add medication to the vapor: Figure 4

1.Switch humidifier off and allow outlet grill to cool down.

2.Lift the outlet grill using the finger grips on each side and remove.

5