Putting It Together
There is only one step required for assembly.
Take the Flex Hose Clip and slide the back plate into the
1. opening on the front of the unit. You will hear a “snap” when it is locked in place.
*Optional on some models.
If your unit comes with a TurboBrush, you will need to attach the TurboBrush Clip.
2. | Slide the TurboBrush Clip into the guides on the vacuum |
Flex Hose storage bracket, on the back of the unit. |
Pre-Treating
1
A
Cleaning effectiveness will be enhanced if you
1. Hold the Cleaning Tool just above the surface of the carpet or upholstery to be cleaned. Depress the trigger to release a spray of cleaning solution directly onto the soiled area.
1
2
B
2. Wait | C | D |
Getting Ready
1. To Fill the Clean/Solution Tank.
A.Remove the tank by lifting it straight up and then away from the unit.
B.Unscrew the black cap at the bottom of the
Clean/Solution Tank.
C.Add BISSELL Little Green Formula to the FORMULA fill line (8 oz.) on the Clean/Solution Tank.
NOTE: Your Little Green is shipped with an 8 oz. Starter bottle of formula.
Fill the Clean/Solution Tank with hot (NOT boiling) tap water to the WATER fill line.
Replace and tighten the black cap.
D.Replace the Clean/Solution Tank by lining up the vertical guides (see #D) on the left side of the unit with the indentations on the Clean/Solution Tank and gently sliding it down into position.
2
3
2.
3.
Unwrap Vacuum Flex Hose completely from Onboard
Hose Storage.
4
Attach your selected cleaning tool to the Spray Trigger Unit by pressing tool onto Spray Trigger firmly until the button lock snaps into hole. Make certain the tool is securely attached.
4. | Twist the Quick Release Cord Wrap clockwise to unwrap |
|
the Power Cord completely from Onboard Cord Storage |
| |
| and plug into 120 Volt, 60 Hz grounded outlet as | 7 |
| described in Important Safety Instructions, page 3. |
|
