Getting Ready Continued

 

Press Power Switch to ON Position.

5.

NOTE: If your unit has a built-in heater (not stan-

 

dard on all models), first turn the black power

 

switch to “ON,” then the red heater switch to

 

“ON”. Within 30 seconds, the Heat Indicator light

 

will illuminate (# 5 in diagram), indicating the

 

heater has reached the proper temperature.

 

Begin use by depressing the Spray Trigger. Wait

 

5-10 seconds for the non-heated water to travel

 

through the Flex Hose, after which the heated

 

water and cleaning solution mixture are ready to

 

clean carpet or upholstery. See below for

 

detailed cleaning instructions.

 

Press and hold Spray Trigger—spray will start in a

6.

few seconds. Raise the tool slightly to check for spray.

WARNING:

Be sure to unplug the cord before attaching the TurboBrush.

5

Heat

Indicator

Light

Power Switch

Heater Switch

6

How To Deep-Clean Carpet and Upholstery

Hold the tool approximately 1” above the soiled surface.

1. Depress the Spray Trigger to apply the cleaning solution to the soiled area.

Using the brush on the tool, gently scrub the area to

2. be cleaned.

Note: If using the TurboBrush, the switch should be in the “BRUSH” position. This activates the brush only.

For thorough cleaning, spray additional solution, while

3. the brush and suction are in contact with the surface.

Apply downward pressure on the tool and pull it toward

4. you. The suction will remove the dirt and cleaning solution. Continue until no more dirt can be removed.

Note: If using the TurboBrush, move the switch to the “SUCTION” position. This activates the suction to remove the dirt and cleaning solution. Move the switch back to the “BRUSH” position for additional brushing action.

As a final step, use “drying strokes” (by not depressing

5. the Spray Trigger) to remove as much liquid/moisture as

possible. Repeat this step as often as necessary.

Note: If using the TurboBrush, move the switch to the “SUCTION” position. This activates the suction to remove the dirt and cleaning solution.

3

SUCTION

BRUSH

IMPORTANT:

Check the manufacturer’s tag before cleaning upholstery. “W” or “WS” on the tag means you can use your Little Green. If tag is coded with an “S” (with diagonal strike-through), or says “Dry Clean Only,” do not proceed. If manufacturer’s tag is missing or not coded, check with your furniture dealer.

Tip:

Tip:

Deep cleaning

Check upholstery

stairs and high-

stuffing before

traffic areas on a

cleaning. Colored

regular basis can

stuffing may

prolong carpet

bleed through

life.

the fabric when it

 

becomes wet.

 

8

Page 8
Image 8
Bissell 1400 How To Deep-Clean Carpet and Upholstery, Press Power Switch to on Position, Detailed cleaning instructions