When You’re Finished
1. | Turn Power Switch to OFF position. |
Note: If your unit has a Built In Heater turn the |
Heater Switch off.
Unplug Power Cord from outlet.
2. Note: If a significant amount of Little Green formula/water remains, it is all right to leave it in the Clean/Solution Tank for your next cleaning task.
Empty and rinse the Dirty/Collection Tank after each use,
3. OR when dirty water reaches the indicated maximum fill line. To remove the tank, lift up the Dirty/Collection Tank retainer lever and remove the tank from the unit.
Disconnect the cleaning tool from the Spray Trigger by
4. pushing down on button lock and pulling straight off (Do NOT twist tools to remove them).
Once removed from the Spray Trigger, all tools can be
5. cleaned by rinsing under clean running water. The TurboBrush tool’s switch must be in “SUCTION” position before rinsing under clean running water.
Check Spray Nozzle for accumulated dirt or debris. If
6. necessary, clean with soft bristle brush.
Storing Your Little Green
Tip:
Before turning off the Little Green, vacuum up clean water to thoroughly rinse out the interior of the Vacuum Flex Hose. Then, lift the cleaning tool and point it upwards to drain any remain- ing water into the Dirty/Collection Tank.
3
Retainer Lever
WARNING:
Keep spray away from face. Failure to do so may result in personal injury.
1.
Wipe all surfaces with a soft cloth.
Wrap Power Cord around the Cord Wrap on the back of
2. the Little Green.
3. | Wrap Vacuum Flex Hose around the base of the unit and |
secure the Spray Trigger. |
Store unit in protected, dry area, at room
4. temperature (40º to 110ºF).
Note: For Little Green TurboBrush Models, onboard storage for the TurboBrush Tool has been provided on the back of the unit. Attach the TurboBrush to the unit by pressing it onto the holder firmly until the button snaps into hole.
9
