Assembly
Tool required: Phillips screwdriver
1.Slide upper handle into lower handle by pushing forward. Insert two long screws into the holes marked with arrows and tighten both until snug.
2.Attach hose rack by placing the rack over the center back portion of the vacuum. Be sure to feed the power cord through the hole in the center of the rack. Line up both screws holes and use the two smaller screws to attach. Tighten both until snug.
3.Attach hose by placing the tabbed end into the lower left opening on corded side of the vacuum. Make sure the tab on the hose cuff and the hole in the vacuum line up. Place the working end of the hose into the hole on the side with the extension wand guides.
4.Arrange the hose so it lays between the vacuum and the rack.
5.Store the TurboBrush on the front of the handle by aligning the slot on the bottom with the tab on the handle. Snap into place.
6.Store the Combination Brush in the slot shown.
7.Make sure the crevice tool is inside the extension wand. Store tools on vacuum as shown.
CAUTION:
Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.
12a
2b3
5
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 5 |
