Bissell 1720 warranty Getting Ready, Pre-treating, Instructions on

How To Deep Clean Carpet or Upholstery

Getting Ready

	1.		Remove Vacuum Flex Hose completely from On Board
			Hose Storage.
			Attach 4” Tool, TurboBrush* or Crevice Tool* to Grip Trigger Unit
		2.
			by pressing Tool onto Grip/Trigger Unit firmly, until button snaps
			into hole. Make certain Tool is securely attached.
			Unwrap Power Cord completely from On Board Cord Storage
		3.
			and plug into 1230 Volt, 60 Hz grounded outlet as described in
			Important Safety Instructions, page 3.
			Turn Power switch to ON Position.
4.
			Note: If your LIttle Green has a built-in heater, refer to
			instructions on page 7.
			Press and hold Spray Trigger on Grip/Trigger unit. Spray will
5.
			start in a few seconds.
6.			Raise the Tool slightly to check for spray. If spray does not
			start, press firmly on the front of the Solution Tank while

depressing Spray Trigger.

*Optional on some Little Green models. To order optional parts not originally included in your Little Green model, call BISSELL Consumer Services at the telephone num- ber listed on page 9.

Pre-treating

Pre-treat stained or highly soiled areas: Hold the flex hose

1. with tool attached above carpet or upholstery, and pull trig- ger to spray cleaning solution.

WARNING:

Be sure to unplug the cord before attaching the Turbobrush.

2.

Wait 3-5 minutes before cleaning.

7