Assembly
The only tool you’ll need to assemble your vacuum cleaner is a Philips head screwdriver.
Remove handle and tools from box
1.Locate and remove the deluxe floor tool, extension wand, bendable wand attachment, dusting brush, TurboBrush®, crevice tool and accessory bag from box.
2.Locate and remove vacuum handle and Twist ‘n Snap Hose and set aside.
3.Lift vacuum body out of box using carrying handle on dirt container.
Warning:
Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
2.
Attach handle to vacuum
1.Take vacuum handle and remove the screw packet taped to the base of the handle.
2.Stand the vacuum upright and slide the base of the handle firmly into the grooves at the top
of the vacuum body. | 4. |
|
3.Check to be sure the handle is fitted to the vacuum body. If there is a gap in front, con- tinue to push firmly until the handle is flush.
4. Insert the two screws from the screw packet into the existing holes. Tighten securely with a screwdriver.
Attach vacuum hose & on-board tools
1.Position the Twist ‘n Snap Hose assembly on the vacuum and line up the tabs on the base of the hose with the corresponding notches.
Turn the Twist ‘n Snap Hose to the right to lock 1. into place.
2.Slide the end of the hose into the hose base. Make sure the tab on hose wand inserts into hole on front side of handle. Place the hose into the hose clip.
NOTE: The powerfoot will not operate effectively | 2. | |
unless the hose is firmly attached to the base. | ||
|
3.Snap the bendable wand attachment into front
side of handle. | 3. |
4.Place the remaining tools into accessory bag.
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 5 |
