Maintenance and care
Cleaning the pre-motor and HEPA media post-motor filter
Unplug the vacuum from electrical outlet.
1. | The |
|
|
|
|
|
| dirt particles. It is located in the filter |
|
|
|
|
|
| compartment underneath the dirt container. If |
|
|
|
|
|
| the filter becomes dirty, lift out the filter and |
|
|
|
|
|
| clean. This filter may be hand washed in cold |
|
|
|
|
|
| water with mild detergent. Rinse well and air |
|
|
|
|
|
| dry thoroughly before replacing. | HEPA Media | ||||
|
| |||||
2. | The HEPA media | |||||
| in the filtration process to return clean air |
|
|
|
|
|
| to the room. It is also located in the filter |
|
|
|
|
|
| compartment underneath the dirt container. |
|
|
|
|
|
| If the filter becomes dirty, open the filter |
|
|
|
|
|
| door, remove the filter and replace. The HEPA |
|
|
|
|
|
| media filter is not washable. |
|
|
|
|
|
|
|
|
| WARNING: |
| |
Rotating brush and drive belt maintenance |
|
|
| |||
|
| |||||
|
|
|
|
| Do not operate cleaner |
|
Check your vacuum cleaner’s rotating floor |
|
|
| with damp or wet |
| |
brush and drive belt regularly for debris, wear or |
|
|
| filters or without all |
| |
damage. Debris can wrap around the brush and |
|
|
| filters in place. |
| |
hamper its ability to effectively clean your carpet. |
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
|
| ||
1.Unplug cleaner from electrical outlet.
2.Recline handle and turn vacuum cleaner over so the bottom side is up.
3.Remove the five screws as shown with a Phillips head screwdriver. Lift the brush cover off.
4.Lift the rotating floor brush from the
3. | ||
tension on belt loosens as shown. Slide | ||
| ||
the belt off the brush and motor pulley to |
| |
remove brush completely. |
|
5.Clean strings, hair and other debris from the brush. Brush ends caps are removable to allow for additional cleaning.
6.Check air passageway for obstructions.
Remove any debris from this area. (see | 6. |
instructions on pg. 11) |
|
7. Clean debris from the motor pulley and drive belt areas.
8.Check drive belt carefully for wear, cuts or stressed areas. If any damage is present, discard old drive belt and replace.
Caution:
To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet.
4.
10 w w w . b i s s e l l . c o m
Air Passageway | 8 0 0 . 2 3 7 . 7 6 9 1 |
|
