Bissell 1867 warranty Cleaning Bare Floors, Routine Maintenance When You’re Done

Sweep or vacuum floor prior to using.

Slowly pass over surface to be cleaned while pressing trigger to emit steam.

Cleaning Bare Floors

Your Steam Mop is designed to clean bare flooring such as ceramic tile, vinyl, laminate, marble, stone and sealed hard wood floors. Use of your Steam Mop on waxed or some unwaxed floors may result in a diminished glossiness. The Steam Mop is not for use on unsealed wood floors. For best results test in an inconspicuous area or check the care instructions from your flooring manufacturer.

1.

2.

To sanitize an area of your floor, leave the Steam Mop over

3. that area for a minimum of 15 seconds, but no longer than 20 seconds. For larger areas, overlap Swivel Head placement.

When the Steam Mop stops emitting steam, simply remove

4. the Water Tank, refill, and continue cleaning.

Tip:

During first use, it may take several seconds for the Steam Mop to begin steaming. The water needs to flow through the Filter to the heater. This delay will only occur during initial use or when using a new Filter.

Routine Maintenance

When You’re Done

1. Unplug Power Cord from outlet.

2.	Carefully remove Mop Pad from Swivel Head, as Mop Pad and
	Lower Assembly will be hot.

Any water remaining in the Water Tank should be emptied

3. prior to machine storage.

Mop Pad can be machine washed in hot water and

4. tumbled dry.

Wrap Power Cord around Quick Release Cord Wrap on side

5. of Steam Mop.

Wipe all surfaces of Steam Mop with a soft cloth. Store

6. upright in a protected, dry area or hang by storage hook.

C A U T I O N :

Upright storage of the Steam Mop with a wet Mop Pad may result in the formation of white marks on your floor. To remove the white marks, clean area with vinegar.

8