Bissell 23B6-J warranty Getting ready, Before you clean, Cleaning hard floors

Operations

Getting ready

1.Attach mop pad

A.Set the mop pad flat on the floor.

B.Line up the mop head and place it inside the mop pad with cord located at rear of mop head. Tighten cord to ensure tight fit.

2.Fill water tank

A.Remove tank by lifting straight up and away from the unit.

B.Unscrew cap and remove from tank.

C.Fill water tank with water. For best results, water should be at room temperature.

D.Replace the assembly cap and tighten until snug.

E.Replace water tank by lining up vertical guides and gently sliding tank into place.

3.Select a steam control setting. Light is for delicate floors such as hardwood and lami- nates. Normal is for everyday cleaning, and Tough is for hard to clean messes.

4.Twist the Quick Release™ cord wrap clockwise to unwrap the power cord completely and plug into a 220V-240V grounded outlet as described on the Important Safety Instructions, page 3.

5.The ready light will illuminate in 30 seconds when the Lift-Off Steam Mop is ready for use.

Before you clean

Thoroughly sweep or vacuum floor prior to cleaning with the Lift-Off Steam Mop.

Cleaning hard floors

Your Lift-Off Steam Mop is designed to clean hard flooring such as ceramic tile, vinyl, laminate, marble, stone and sealed hard wood floors. Use of your Lift-Off Steam Mop on waxed or some unwaxed floors may result in a dimin- ished glossiness. The Lift-Off Steam Mop is not for use on unsealed wood floors. For best results test in an inconspicu- ous area and check the care instructions from your flooring manufacturer.

2A2B

2D2E

7

w w w. b i s s e l l . c o m