Cleaning with the Canister - continued
Tip:
Before cleaning under low furni- ture, check for objects that might block the vacuum hose. Do not pick up hard or sharp objects such as glass, nails, screws, coins, paper clips, etc.
Above Floor Cleaning
For quick and easy above floor cleaning:
1.Detach the Hose from the Hose Port at the bottom/back of the Canister. Press the lock button and pull the Hose from the Port, then insert the Crevice Tool into the end of the Hose.
To resume normal floor vacuuming:
1.Remove Crevice Tool and store in Crevice Tool Clip.
2.Reconnect Hose to the Hose Port, making certain it is locked fully in place.
3.Attach Floor Nozzle and Upright Handle, following instructions in “How To Put It Together,” page 4.
Emptying the Dirt Cup
Your EASY VAC™ features a translucent plastic Dirt Cup, so you can easily see when it needs to be emptied. For best performance, empty when debris reaches halfway up the cup. 1. Press the lock button down and forward
(away from the Canister Handle) while lifting the upper portion of the Dirt Cup away from the Canister.
2. Grasp the Filter frame and pull it straight from the Cup. Empty the Cup, and check both the filter and the Cup for cleanliness and damage. You may wash the Cup with warm (not hot) water and mild liquid dish
soap only. Rinse and dry thoroughly before reattaching it.
3. If the surface of the filter looks dirty or discoloured, now’s the time to clean or
replace it. To clean the filter, remove any debris still clinging to the filter. After a time, it will be necessary to replace your filter. See “Routine Maintenance” for instructions.
4.With filter in place at the top of the Cup,* place the small tab at the bottom of the Canister cavity, then press the upper portion of the Cup into place until the lock button can easily be pushed back into position.
*Push filter down tight to ensure gasket is in place.
Power Cord Storage
When you are done using your BISSELL EASY VAC,™ store the Power Cord.
1.Turn EASY VAC™ off by moving switch to “ 
” position.
2.Unplug Power Cord by grasping the polarized plug [NOT the cord) and disconnect from outlet.
3.Loop Power Cord around Cord Wraps on side of cleaner, making certain Quick Release Cord Hook is pointed up toward the Handle.
4.Clip molded plug to Power Cord to secure.
6
