Bissell 3302 Battery Removal and Disposal, To empty your filter, Replacement Filters, Maintenance

Models: 3302 3301 3300

1 10
Download 10 pages 31.17 Kb
Page 7
Image 7
Maintenance

Maintenance

The key to maximum performance is a clean Filter. Emptying the Filter after each use, and cleaning it periodically, will help your Go Vac operate at peak efficiency. Replacement Filters are available. See below.

To empty your filter:WARNING:

Never operate your Go Vac without the Filter in place. Doing so may damage the motor and void the warranty.

To empty your filter:

1.With Go Vac facing away from you, grasp Dust Cup in right hand and turn it toward you (toward back of Go Vac).

2.Carry the Dust Cup, with filter in place, to a waste container. Remove Filter, shake debris from Filter and Dust Cup, then replace Filter in Dust Cup.

3.Replace Dust Cup by placing it in position and turning it away from you until it fits securely.

4.Clean exterior surfaces with a soft cloth dampened with water only. Do not use a strong detergent or other cleaner - this may damage the finish. Always remove the Go Vac from the Charging Base or unplug it from the wall outlet before cleaning the surface.

5.After heavy usage, you may clean the Filter by gently rinsing it in a bowl of water and mild dish detergent. Rinse thoroughly under running water and make certain it is completely dry before replacing it. You may also purchase replacement Filters.

Replacement Filters

Use only BISSELL Filters in your BISSELL Go Vac. If your Filter becomes damaged or becomes too dirty to wash, you may purchase new filters with the order form in this User’s Guide, or by calling

BISSELL Consumer Services 1-800-237-7691

Monday - Friday 8 a.m. — 7 p.m. EST

Saturday 9 a.m. — 2 p.m. EST

Or visit our website @ www.bissell.com

10 Screws

Battery Removal and Disposal

Replacement FiltersWARNING: This product contains a rechargeable nickel cadmium battery (sometimes referred to as a “Ni-Cad” battery) pack. According to Federal and State regulations, proper removal and disposal of Ni-Cad batteries is required.

For removal of the battery pack in your Go Vac, see instructions below:

1.IMPORTANT: Unplug charger.

2.Remove screws (10) holding Product Housing together (see diagram).

3.Separate Housings and locate Battery Pack in bottom/center of unit.

4.Remove wire connectors from the Battery Pack.

5.Keep Battery Pack together - DO NOT separate individual batteries. For specific disposal instructions of batteries, please contact:

RBRC (Rechargeable Battery Recycling Corporation) 1-800-822-8837.

6. Discard remainder of product.

7

Page 7
Image 7
Bissell 3302, 3301, 3300 warranty Battery Removal and Disposal, To empty your filter, Replacement Filters, Maintenance