Charging the battery
Your Go Vac may be stored in the Charging Base whenever it is not in use. When Go Vac is charging, it may become warm to the touch. This is normal, and no cause for concern. Here are some things to remember about charging:
1.When completely charged, your Go Vac provides over 12 minutes of full cleaning power.
2.When charging for the first time, allow to charge uninterrupted for at least 24 hours. Thereafter, a 12
3.Model 3300 features a single red Indicator Light. This light does not go off when the Go Vac is fully charged. Unplugging the Charging Base cord from the wall outlet after 6 - 8 hours will extend the life of the battery.
4.Model 3302 [Fast Charger] features a red and a green Indicator Light. When in charge mode, the red light will glow. When the battery is fully charged and ready for use, the red light will go out and the green light will glow - usually in 3 hours.
IMPORTANT NOTE: If you purchased a 3302 Go Vac unit equipped with the fast charger, you should let the vacuum cool down before placing into the charging base. The charger features a heat sensitive device that will indicate to the vacuum that it is already charged. (Placing the unit while warm, into the vase will take longer to charge.)
5.Decreased operating time may indicate that the battery has built up a charging resistance. To recharge, first completely exhaust the battery, recharge it, then exhaust it again before recharging a second time. This procedure may be required more than once. If your battery still fails to recharge, or does not hold a charge of normal duration, call:
BISSELL Consumer Services 1-800-237-7691
Monday - Friday 8 a.m. — 7 p.m. EST Saturday 9 a.m. — 2 p.m. EST
Or visit our website @ www.bissell.com
NOTE: Charging Bases are not interchangeable between models.
6
How to use your Go Vac
Your Go Vac is a quick and easy way to clean up around the house, inside the car or truck, or in the workroom.
Off | On | |
1. Release the Go Vac from the | ||
| ||
Charging Base by lifting it |
| |
straight up and out. |
| |
2. Tip back the Handle into |
| |
typical use position, and |
| |
your Go Vac turns on by |
| |
itself. To turn Go Vac off again, |
| |
return Handle to upright position. |
|
3.To clean stairs, vehicles or small areas, detach the Handle by depressing the button where the bottom of the Handle slides into the Go Vac, and pull the entire Handle assembly out. Use the Go Vac by holding the
4.When done, replace the Handle (if detached) and place the Go Vac in the Charging Base. Make certain red charging light is on when Go Vac is in place.
NOTE: For Model 3301, simply remove the Charging Plug from the port at the motor side of the Go Vac, and use as above.
